Page 1
HP 1410 Switch Quick Setup Guide The switch images in this document are for illustration only and may not match your particular switch model. For detailed information to set up your switch, view or download the Installation and Getting Started Guide for your switch at www.hp.com/networking/support.
Page 2
Install the Switch Hardware (Continued) M-4 tap Wall (or Under-Table): A hardware kit for wall-mounting (or screws under-table mounting) is included. Use a #1 Phillips (cross- head) screwdriver and the 20-mm M4 tap screws (included). For screw positions, see the mounting hole dimensions on page 4.
Ensure the air flow around the switch is not restricted. Leave at least 7.6 cm (3 inches) for cooling. For other available ■ air flow information, see the Installation and Getting Started Guide for your product, located on the HP Web site at www.hp.com/networking/support.
(Under-table mounting) After installation, prevent switch movement by placing a third screw along this side. Table 1. Mounting Hole Dimensions Switch Model Hole-to-Hole Dimension 1410-8 3.54 inch (90.0 mm) 1410-16 5.91 inch (150.0 mm) 1410-24 5.91 inch (150.0 mm) 1410-24-2G 5.91 inch (150.0 mm)