Advertisement
Quick Links
Symmetry Unit Equipment
6 and 12 Volt
18 to 72 Watt
120/100V 50/60Hz
Service Questions Call: 910-259-1000
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed, including
the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
All servicing should be performed by qualified
personnel only.
Equipment should be mounted in locations and at
heights where it will not be readily subjected to
tampering by unauthorized personnel.
The use of accessory equipment not recommended
by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended
use.
Do not let supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Caution: Halogen cycle lamp(s) are used in this
equipment. To avoid shattering: Do not operate
lamp in excess of rated voltage, protect lamp
against abrasion and scratches and against liquids
when lamp is operating, dispose of lamp with care.
Philips Lighting North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
INSTALLATION AND
OPERATING
INSTRUCTIONS
Halogen cycle lamps operate at high temperatures.
Do not store or place flammable materials near
lamp.
Use caution when servicing batteries. Battery acid
can cause burns to skin and eyes. If acid is spilled
on skin or eyes, flush acid with fresh water and
contact a physician immediately.
CAUTION: To avoid electrical overload, total
connected lamp load (factory and field installed)
should not exceed output rating.
SAVE THESE
INSTRUCTIONS
WARNING – Shut off AC power to branch
circuits to which units will be connected. All
wiring should be per N.E.C. Articles 501-4(b)
and local codes.
To maintain warranty, equipment with batteries
must be installed or placed on charge within
prescribed period after shipment.
GENERAL INSTRUCTIONS
Philips Lighting Canada Ltd.
281 Hillmount Road,
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
9140053520 February 2016
Advertisement
Related Manuals for Philips Symmetry Series
Summary of Contents for Philips Symmetry Series
- Page 1 9140053520 February 2016 Philips Lighting North America Corporation Philips Lighting Canada Ltd. 200 Franklin Square Drive 281 Hillmount Road,...
- Page 2 If unit is not used to power any remote heads, be certain to insulate the unused orange and yellow leads to prevent shorting or discard the 6” orange/yellow extension cable. 9140053520 February 2016 Philips Lighting North America Corporation Philips Lighting Canada Ltd. 200 Franklin Square Drive...
- Page 3 Energize AC supply branch circuit and refer to page 5 for operating instructions. No rigid conduit – Flexible conduit only 9140053520 February 2016 Philips Lighting North America Corporation Philips Lighting Canada Ltd. 200 Franklin Square Drive 281 Hillmount Road,...
-
Page 4: Maintenance
TAMPERPROOFING – If ordered, install this option using the included screw kit which includes two flat head screws, two pan head screws and a tamperproof Torx T-15 bit. 9140053520 February 2016 Philips Lighting North America Corporation Philips Lighting Canada Ltd. 200 Franklin Square Drive... - Page 5 IR Remote Control (optional)- is a hand held device that allows remote activation of diagnostic testing and silencing of the optional buzzer during fault conditions. 9140053520 February 2016 Philips Lighting North America Corporation Philips Lighting Canada Ltd. 200 Franklin Square Drive...
- Page 6 9140053520 February 2016 Philips Lighting North America Corporation Philips Lighting Canada Ltd. 200 Franklin Square Drive 281 Hillmount Road, Somerset, NJ 08873, USA Markham ON, Canada L6C 2S3 Phone: 855-486-2216 Phone: 800-668-9008 www.philips.com/luminaires www.philips.com/luminaires...