Dell Networking 207 Series Regulatory Compliance And Safety Information Manual

Dell Networking 207 Series Access Points
Regulatory Compliance and Safety Information Guide
Introduction
This document contains domestic and international regulatory compliance and safety information for Dell Networking 207 Series access points (W-AP207 and
W-IAP207). To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.
Electrical and Environmental Specifications

Regulatory Information

Proper Disposal of Dell Equipment

Electrical and Environmental Specifications
For additional specifications on this product, please refer to the product data sheet at dell.com
CAUTION: All Dell access points should be professionally installed by a certified technician. The technician is responsible for ensuring that
grounding is available and meets applicable national and electrical codes.
ATTENTION: Tous les points d'accès Dell doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer que
l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.
Electrical
Ethernet:

One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45)

Power:

Maximum power consumption (excluding USB):13.5W (PoE) or 12W (DC)

Direct DC source: 12Vdc nominal, +/- 5%

Power over Ethernet (PoE): 802.3af complaint source

Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.

NOTE:
If a power adapter other than the Dell-approved adapter is used in the US or Canada, it should be NRTL listed, with an output rated 12Vdc,
minimum 2A, marked "LPS" and "Class 2", and suitable for plugging into a standard power receptacle in the US and Canada.
Environmental
Operating:

Temperature: 0°C to +50°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport

Temperature: -40°C to +70°C (-40°F to +158°F)

Regulatory Information
The following regulatory model names apply to the 207 Series access points:
W-AP207/W-IAP207: APIN0207

NOTE:
For country specific restrictions and additional regulatory and safety guidelines, refer to the
Environmental and Regulatory Information
CAUTION: Access points are classified as radio transmission devices, and are subject to government regulations of the deploying country. The
Network Administrator(s) are responsible for ensuring that the configuration and operation of this equipment is in compliance with their
country's regulations. Specifically, access points must use channel assignments appropriate to the locale in which the access points will be
used. For a complete list of approved channels in your country, refer to the Downloadable Regulatory Table (DRT) release notes at dell.com
0511921-01 | October 2016
document included with Dell controllers and Instant access points.
Dell Networking W-Series Safety,
1