Advertisement
Quick Links
CMFIC/TMFIC Series
25W-50W Emergency
Luminaire
Service Questions Call: 910-259-1000
INSTALLATION AND
OPERATING
INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed, including
the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
All servicing should be performed by qualified
personnel only.
Equipment should be mounted in locations and at
heights where it will not be readily subjected to
tampering by unauthorized personnel.
The use of accessory equipment not recommended
by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended
use.
Do not let supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Chloride is a Philips group brand
This datasheet has been downloaded from
CAUTION: Halogen cycle lamp(s) are used in
this equipment. To avoid shattering: Do not
operate lamp in excess of rated voltage, protect
lamp against abrasion and scratches and against
liquids when lamp is operating, dispose of lamp
with care.
Halogen cycle lamps operate at high temperatures.
Do not store or place flammable materials near
lamp.
CAUTION:
connected lamp load (factory and field installed)
should not exceed output rating".
WARNING – Shut off AC power to branch
circuits to which units will be connected. All
wiring should be per N.E.C. Articles 501-4(b)
and local codes.
To maintain warranty, equipment with batteries
must be installed or placed on charge within
prescribed period after shipment.
Pg -1-
9140053340 Rev. 0
http://www.digchip.com
"To avoid electrical overload, total
SAVE THESE
INSTRUCTIONS
at this
page
Advertisement
Related Manuals for Philips CHLORIDE CMFIC Series
Summary of Contents for Philips CHLORIDE CMFIC Series
- Page 1 Do not let supply cords touch hot surfaces. prescribed period after shipment. Do not mount near gas or electric heaters. Chloride is a Philips group brand Pg -1- 9140053340 Rev. 0 This datasheet has been downloaded from http://www.digchip.com...
-
Page 2: General Instructions
LED will then flash exceed unit rating. slowly for approximately 36-72 hours to 2. Adjust head(s) to illuminate desired area(s). indicate the unit is in a high rate of charge. Chloride is a Philips group brand Pg -2- 9140053340 Rev. 0... -
Page 3: Self-Test / Self-Diagnostics
Failure Codes Table 2 control by pressing in sequence, ‘Silence, below. Silence, Cancel, Silence’. The lamps will illuminate for a brief time and then return to normal operation status. Chloride is a Philips group brand Pg -3- 9140053340 Rev. 0... - Page 4 Unit connected to lower minute check each month and a 30 minute Red (Slow) than allowable voltage. test each 6 months. Check line input wiring for correct voltage connections. Table 2 Chloride is a Philips group brand Pg -4- 9140053340 Rev. 0...
-
Page 5: Optional Remote Control
Cancel stops any test currently in process. Back Explanation of indicator light flash sequences. Refer to Table 2 above for further information. Chloride is a Philips group brand Pg -5- 9140053340 Rev. 0... - Page 6 BATTERY HOOKUP DIAGRAMS LEAD BATTERY HOOKUP NICAD BATTERY HOOKUP 6V 25W LEAD 6V 25W NICAD 6V 50W NICAD 6V 50W LEAD 12V 25W NICAD 12V 50W LEAD 12V 50W NICAD Chloride is a Philips group brand Pg -6- 9140053340 Rev. 0...