Form No. 3361-406 Rev B Left and Right Hand Light Kits 2009-2011 Workman HD/HDX/HDX-D Series Utility Vehicle Model No. 07315 Model No. 07317 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped.
Disconnecting the Negative Battery Cable No Parts Required Procedure 1. Position the vehicle on a level surface, stop the engine, engage the parking brake and remove the key from the ignition. 2. Remove the battery cover. 3. Disconnect the negative battery cable from the battery.
Figure 3 1. 1/4 inch diameter holes 2. 1–3/8 to 1–1/2 inch Figure 2 diameter hole 1. Old head lights 2. New Main beams 3. Secure a position light to the hood at each location 3. Plug a harness adapter onto each main beam. with (2) retainers (Figure 2).
Figure 5 1. Old Tail light 2. New Tail light 2. Unplug the wire harness connectors from the tail light connectors. Remove the lights. 3. Plug the wire harness connectors to the new tail light connectors. 4. Mount the tail lights to the fender brackets with the fasteners previously removed (Figure 5).
Figure 6 1. Signal controller 3. Old screws 2. Nuts 4. New screws Figure 8 1. Wire harness 2. Under the steering wheel, remove the two screws securing the console to the steering pump (Figure 7). 6. Locate the vehicle wire harness labeled signal controller and plug it into the signal controller harness.
Connecting the Negative Battery Cable No Parts Required Figure 10 Procedure 1. Decal 2. Switch 1. Connect the negative battery cable to the battery. 3. Affix the decal to the dash panel, next to the switch 2. Install the battery cover. (Figure 10).