Page 1
Form No. 3385-461 Rev A Door Kit with Sliding Window Workman ® MDX or HDX Utility Vehicle Model No. 07356 Model No. 07393 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2
2. Install the 4 washers over the 4 hinge pins at the cab frame for the machine (Figure 2). 3. Install the door onto the hinge pins mounted on the cab frame (Figure 2). Figure 3 1. Ball stud (cab frame) 3.
Page 3
Assembling the Latch Pins Assembling the Door Lanyards Parts needed for this procedure: Parts needed for this procedure: Lanyard Hex nut (7/16 inch) Shoulder bolt (5/16 x 1/2 inch) Latch pin Locknut (5/16 inch) Latch-pin cam Thrust washer Procedure Pin guard 1.
Page 4
Note: If the height measured is more than the zone specification, rotate the latch-pin cam 45° toward the inside of the cab to achieve the specified measurement. If the height measured is less than the zone specification, perform the opposite of the above Adjusting the Door-latch Pin procedure.
Operating the Sliding Window Operation Open the latch to open and close the sliding window (Figure Using the Door 11). 1. Insert the key into the opening on the handle if the door is locked, and rotate the key to the open position (Figure 10).