JVC LT-40CF890 Unpacking Manual

Unpacking Guide
TV
Instruction Book
& Quick Start Guide
TV Stand Neck
Accessories
Pack
Screws
TV Stand Base
Attaching the Neck
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Keep the protective bag on the TV to protect it. You may need to cut the protective bag before fitting the stand.
3. Make sure you have some help, this requires 2 people. Lay the TV down on a flat surface ideally on the edge of a
table so the base of the TV slightly overhangs the edge of the table, with the back side facing up. Please make sure
a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen. Be very
careful not to knock the edges of the TV, the screen is very fragile.
4. Attach the neck using 4 x screws (A) 16mm.
Fitting the Base
5. Attach the base using 4 x screws (B) 16mm. Be careful when attaching the base its heavy.
• Keep the protective bag on your TV until you have attached the
stand and positioned the TV.
• The LCD display is very fragile, and must be protected at all times
when installing and removing the base stand. Be sure that no hard
or sharp object, or anything that could scratch or damage the LCD
display, comes into contact with it. DO NOT exert pressure on the
front of the TV at any time because the screen could crack.
JVC 40'_49'_55' Amazon Fire LED Smart 4K HDR TV LT-40CF890 LT-49CF890 LT-55CF890 Unpacking Guide.indd 1
✔
2 people are required
when unpacking your TV.
Table
If you don't have a table
big enough, you can use
the TV box. Lie the box flat,
make sure you place the
polystyrene back in the box
first to give the box some
rigidity and strength.
✘
Cushioned
material
Don't lift the TV from the top
Remove the Protective Bag
21/10/2019 11:14