Sealey SA811 Quick Start Manual

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear
instructions eye Protection
1. safety
Familiarise yourself with the application and limitations of the air hose reel, as well as the specific hazards.
9
WaRNiNG! disconnect the air hose reel from the air supply before servicing or performing any maintenance.
‰
maintain the air hose reel in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
locate and fix the air hose reel in a suitable working area, ensure that the correct fixings are used to secure the unit to the wall.
9
Do Not position the hose in direct sun light, or in areas of extreme heat or cold.
8
Do Not mount inside spray booth/oven.
8
ensure that there is adequate lighting.
9
WaRNiNG! ensure maximum air pressure is not exceeded.
‰
WaRNiNG! Do Not over extend the hose as this will cause the mechanism to malfunction, preventing the hose from retracting.
‰
Keep extended air hose away from heat, oil and sharp edges.
9
Check hose for wear before each use and ensure all connections are secure.
9
Keep the unwound air hose away from wet, damp, oily surfaces.
9
WaRNiNG! Always wear approved eye protection when operating the air hose reel.
‰
maintain correct balance and footing. ensure the floor is not slippery and wear non-slip shoes.
9
Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long hair.
9
Keep children and unauthorised persons away from the working area.
9
Do Not operate the air hose reel if any parts are damaged or missing as this may cause failure and/or personal injury.
8
Do Not use the air hose reel for any purpose other than that for which it is designed.
8
Do Not yank the hose from the air supply.
8
Do Not operate the air hose reel when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
Do Not direct air from the air hose at yourself or others.
8
When not in use, ensure the air supply is turned off and tools disconnected. disconnect from the air supply and retract the hose into
9
case.
WaRNiNG! DO NOT dismantle the hose reel casing. To do so may result in damage to the appliance and/or personal injury and will
‰
invalidate the warranty. Internal maintenance, which will require the opening of the casing, must only be undertaken by an authorised
service agent.
2. iNtRoDuctioN
Heavy-duty polypropylene casing. double braided polyurethane hose fitted with 1/4"BSP female inlets and 1/4"BSPT male outlets. Features auto
layering mechanism which distributes air hose evenly back into the reel housing preventing it from jamming. Supplied with mounting bracket and
fixing kit for attachment onto walls or ceilings.
3. specificatioN
MoDel No. . . . . . . . . . . . . . . . . . . . . . . sa811 . . . . . . . . . . . . . . . . . sa812.V3 . . . . . . . . . . . . . . sa813.V3 . . . . . . . . . . . . . . . . . sa814.V2
Hose length . . . . . . . . . . . . . . . . . . . . . . . .6.5m . . . . . . . . . . . . . . . . . . . . . .12m . . . . . . . . . . . . . . . . . . . 10m . . . . . . . . . . . . . . . . . . . . . . 15m
Hose Size Id/od . . . . . . . . . . . . . . . .6.5/10mm . . . . . . . . . . . . . . . . 6.5/10mm . . . . . . . . . . . . . . . . 8/10mm . . . . . . . . . . . . . . . . . . . 8/10mm
maximum pressure. . . . . . . . . . . . . . . . . 150psi . . . . . . . . . . . . . . . . . . . . 150psi . . . . . . . . . . . . . . . . . 150psi . . . . . . . . . . . . . . . . . . . . 150psi
Inlet - outlet . . . . . . . . . . . . . . . . . . . . . 1/4"BSP . . . . . . . . . . . . . . . . . . .1/4"BSP . . . . . . . . . . . . . . . .1/4"BSP . . . . . . . . . . . . . . . . . . . 1/4"BSP
4. MouNtiNG
WaRNiNG! ensure the hose is disconnected from the air supply. Do Not position the hose in direct sun light or in areas of
‰
extreme heat or cold.
4.1. ensure that the structure to which the air hose is to be fixed is of sound construction and that the securing point will hold the working
strain of the hose when in use.
4.2. To wall mount the reel, first remove the wall mounting bracket (fig.1A) from the reel, pull out the bracket retaining screws (fig.1B) to
release the bracket. Position the bracket on the wall surface and mark out the mounting holes, having checked that the main body will
turn sufficiently to allow the hose to be extended without rubbing on either side of the air hose housing.
4.3. drill the holes larger than the screws that will be used to secure the hose reel. Insert wall plugs into the holes and screw mount the
bracket and reattach the hose reel.
4.4. Before use, check that all fixings are safe and secure, and that the hose extends and retracts with ease.
© Jack Sealey limited
RetRactable aiR Hose
sa811, sa812.V3, sa813.V3, sa814.V2
model no:
Original Language Version SA811,SA812.V3,SA813.V3,SA814.V2 | Issue 2 (HF) 28/03/18