Sealey ATL09.V3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL SAFETY Numbers refer to diagram below.
WARNING! Risk of falling (1).
‰
Refer to instruction manual (2).
9
Inspect ladder after delivery. Before every use check the ladder is not damaged and
9
is safe to use. DO NOT use a damaged ladder (6).
DO NOT exceed maximum load (3).
8
DO NOT use the ladder on an unlevel or unfirm base (14).
8
DO NOT overeach (11).
8
DO NOT use on contaminated (by oil or water) ground.
8
Maximum number of users is one (9).
9
DO NOT ascend or descend unless you are facing the ladder.
8
DO NOT climb above the rung or tread indicated by the producer. The minimum
8
requirement shall always be DO NOT climb above the top 3 steps/rungs. (13)
Keep a secure grip on the ladder when ascending or descending. Maintain a
9
handhold whilst working from a ladder or take additional safety precautions if you can
not.
Avoid work that imposes a sideways load on ladders, such as side-on drilling through
9
solid materials.
DO NOT carry equipment which is heavy or difficult to handle while using a ladder.
8
DO NOT wear unsuitable footwear when climbing a ladder.
8
DO NOT use a ladder if you are not fit enough. Certain medical conditions or
8
medication, alcohol or drug abuse could make ladder use unsafe.
DO NOT spend long periods on a ladder without regular breaks (tiredness is a risk).
8
Prevent damage of the ladder when transporting e.g. by fastening and, ensure they
9
are suitably placed to prevent damage.
Ensure the ladder is suitable for the task.
9
DO NOT use the ladder if contaminated, e.g. with wet paint, mud, oil or snow.
8
DO NOT use the ladder outside in adverse weather conditions, such as strong wind.
8
For professional use a risk assessment shall be carried out respecting the legislation
9
in the country of use.
When positioning the ladder take into account risk of collision with the ladder e.g.
9
from pedestrians, vehicles or doors. Secure doors (not fire exits) and windows where
possible in the work area.
WARNING! ELECTRICITY HAZARDS Identify any electrical risks in the work
‰
area, such as overhead lines or other exposed electrical equipment and DO NOT use the ladder use the ladder where
electrical risks occur.
Use non-conductive ladders for unavoidable live electrical work.
9
DO NOT use ladder as a bridge.
8
DO NOT step off the side of a standing ladder onto another surface.
8
DO NOT modify the ladder design.
8
DO NOT move a ladder while standing on it.
8
For outdoor use caution to the wind.
9
Check ladder is correct for professional/domestic use (16/17).
9
1.2. LEANING LADDERS
Leaning ladders with rungs shall be used at the correct angle (5).
9
Leaning ladders with steps shall be used so that the steps are in a horizontal position.
9
Ladders used for access to a higher level shall be extended at least 1m above the landing point and secured, if necessary (4).
9
Only use the ladder in the direction indicated, only if necessary due to the design of the ladder (7).
9
DO NOT lean the ladder against unsuitable surfaces (15).
8
Ladder shall never be moved from the top.
9
DO NOT stand on the top three steps/rungs of a leaning ladder. For telescopic ladders the last metre shall not be used.
8
Open the ladder fully before use.
9
Use the ladder with restraint devices engaged only.
9
Standing ladders shall not be used as a leaning ladder unless it is designed to do so.
9
Locking devices shall be checked and be fully secured before use if not operated automatically.
9
1.3. SAFETY REQUIREMENTS SPECIFIC TO TELESCOPIC LADDERS
All locking mechanisms for all extended rungs/steps shall be locked and checked before use (8).
9
Follow instructions for handling of locking mechanisms including indication of locked or unlocked position.
9
DO NOT bring your hands/fingers in rung area (area of shearing) when bringing the ladder in to its possible positions of use (10).
8
© Jack Sealey Limited
ALUMINIUM TELESCOPIC LADDER
ATL09.V3, ATL11.V3, ATL13.V3
MODEL NO:
Original Language Version ATL09.V3,ATL11.V3,ATL13.V3 | Issue 1 14/05/20