Sealey LEDWC03 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMP P OR R TA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH H E P P RO O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE E RS S ON N AL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL SAFETY
 Ensure the lamp is fully charged before initial use.
 DO NOT turn the lamp on when it is being charged.
DO NOT shine directly into your, another person's or an animal's eyes.

 DO NOT allow children to use the lamp.
 DO NOT handle or move the lamp whilst it is being charged.
 DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
 DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
1.2. BATTERY SAFETY
 WARNING! To reduce the risk of burns or fi re:
 DO NOT attempt to open, disassemble, modify or service the battery pack.
 DO NOT crush, puncture, short external contacts or dispose of in fi re or water.
 DO NOT expose to temperatures above 60°C (140°F).
Recycle or dispose of used battery as stipulated by local regulation.

2. INTRODUCTION
LEDWC03: Fully versatile inspection lamp with dimming function. Supplied with one strong magnet on the base and two on the back. Front
lamp produces up to 250lm dimming all the way down to 15lm. The top spotlight acts as a torch at 100lm. Operating time is 3hr for the main
light and up to 6hr on the spotlight. Charge time 4hr. Supplied with Type C USB cable. Compatible with Model No's WCB3 and WCB4 wireless
charging bases sold separately.
LEDWC04: Fully versatile inspection lamp with dimming function. Supplied with one strong magnet on the base and two on the back. Front
lamp produces up to 500lm dimming all the way down to 15lm. The top spotlight acts as a torch at 100lm. Operating time is 2.5hr for the main
light and up to 10hr on the spotlight. Charge time 4.5hr. Supplied with Type C USB cable. Compatible with Model No's WCB3 and WCB4
wireless charging bases sold separately.
3. SPECIFICATION
MODEL NO: .........................................................LEDWC03 ...................................................LEDWC04
Battery: ...............................................3.7V Li-Poly 1800mAh ................................... 3.6V Li-ion 2500mAh
Charging Time: ..................................................................4hr .......................................................... 4.5hrs
IP Rating: ........................................................................IP54 .............................................................IP54
LED Type: ..............................................3W COB + 1W SMD .................................... 5W COB + 1W SMD
Lumen Output: .............................Side; 15-250lm/Top; 100lm ..........................Side; 15-500lm/Top; 100lm
Operating Time: .........................................Side; 3hr/Top; 6hr ................................... Side; 2.5hr/Top; 10hr
The battery fi tted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before fi rst use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not
replace the battery regardless of whether it is less than one year old.
NOTE: The lithium battery does not suff er from memory eff ect and once fully charged may be stored for up to six months without another
charge.
4. OPERATION
4.1. CHARGING THE LAMP
4.1.1. Place lamp on charging base (fi g.1). The blue indicator
light will turn off when charged.
4.1.2. To charge via a 'type C' cable lift the fl ap on the side of
the lamp marked 'input' and connect cable.
4.2. OPERATING THE LAMP
4.2.1. Push the button marked with the power symbol once to
turn the end light on and twice to activate the large light
on the side of the lamp.
© Jack Sealey Limited
COB & SMD LED INSPECTION LAMP -
WIRELESS RECHARGEABLE
LEDWC03 & LEDWC04
MODEL NO:
Original Language Version
fi g.1
LEDWC03 & LEDWC04 Issue 2 28/07/2021