Sealey LED4491 Quick Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL SAFETY
WARNING! These torches are highly powerful and can get hot very quickly! Please be sure to take care when using and
‰
storing the unit.
DO NOT cover the lens whilst the torch is on and allow sufficient time to cool before storing.
8
Ensure the lamp is fully charged before initial use.
9
DO NOT turn the torch on when it is being charged.
8
DO NOT shine directly into your, other person's or animal's eyes.
8
DO NOT allow children to use the torch.
8
DO NOT handle or move the torch whilst it is being charged.
8
DO NOT use the torch if you suspect that the battery or the torch casing is damaged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
1.2. ELECTRICAL SAFETY
Use only the USB charging lead supplied to charge the battery.
9
WARNING! It is the user's responsibility to read, understand and comply with the following electrical instructions:
‰
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
9
An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD
(Residual Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an RCCB. You must also read and understand the following instructions concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply.
9
DO NOT use if worn or damaged.
8
1.3. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT Attempt to open, disassemble, modify or service the battery pack.
8
DO NOT Crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT Expose to temperatures above 60°C (140°F).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with water. If it gets in your eyes, rinse thoroughly with cool water and
9
seek immediate medical attention.
2. INTRODUCTION
Super powerful COB/LED produces extremely bright, white light with an outputs ranging from 750 - 4000 lumens and a working range of 100-
200 metres. Focus type can be changed from spotlight to wide area by a twist action of the head. Lightweight aluminium housing. Two power
options, full power and 30% energy saving mode. Powered by rechargeable Li-ion batteries. Strong magnet on the base. Supplied with micro
USB charging lead.
3. SPECIFICATION
Model No:........................................ LED4491 ............................... LED4492 .............................. LED4493 ................................ LED4494
Battery: .................................. 3.7V 2AH Li-ion ..................... 3.7V 2AH Li-ion .................... 7.4V 2AH Li-ion ...................... 7.4V 4AH Li-ion
LED Qty: ................................ 5W CREE XPG ................... 10W CREE XM-L ..............20W CREE XHP50 ............................... 60W COB
Lumen Output: .........High: 750lm/ Low: 225lm ..... High: 1000lm/ Low: 300lm ....High: 2000lm/ Low: 600lm .... High: 4000lm/ Low: 1200lm
Operating Time: ................ High: 2hr/ Low: 4hr ................ High: 2hr/ Low: 4hr ...............High: 2hr/ Low: 4hr .............. High: 4hr/ Low: 8.5hr
Range: ................................................... 100m ..................................... 100m .................................... 200m ...................................... 100m
© Jack Sealey Limited
5W CREE XPG3 LED RECHARGEABLE
ALUMINIUM TORCH - ADJUSTABLE FOCUS
LED4491, LED4492, LED4493 & LED4494
MODEL NO:
Original Language Version LED4491, LED4492, LED4493 & LED4494 Issue 2 (1) 30/04/20