Sealey IR1000ST.V2 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
WarnInG! ensure Health & safety, local authority, and general workshop practice regulations are adhered to when using this stand.
‰
use the stand in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
do not use the stand for any purpose other than that for which it is designed.
8
do not leave unattended when in use with the panel heater.
8
do not use stand on uneven ground.
8
do not use stand if any part is significantly damaged.
8
ensure the ir1000 lamp is securely fixed to the stand using the correct mounting bracket.
9
Keep children and unauthorised persons away from the work area.
9
note! for further safety instructions regarding the correct and safe use of the panel dryer please see the instructions supplied with the
ir1000 infrared short wave Panel dryer.
2. IntroductIon
Sturdy 2100mm plated steel stand. Combines all the features of a flexible hand-held heater, with all the benefits of a free standing panel dryer. Full
height 'slide and lock' heater bracket. Ideal for use on small repairs and drying jobs, for example engine drying,stripe removal, filler drying, stone
chip repairs and preheating prior to spraying. Easy assembly and designed to suit Model No. IR1000 Hand-Held Infrared Panel Dryer.
3. specIfIcatIon
model no ................................................................ ir1000st
maximum lamp Height ............................................ 2150mm
4. asseMbly
Assemble stand according to the diagram/pictures below attached.
4.1. Screw the four foot pads into the legs as fig.1.
4.2. Bolt pole support to legs fig.2. using the four bolts washers and nuts supplied.
4.3. screw the three upright sections together.
4.4. using remaining bolt and washer fix the pole to the pole support fig.3.
4.5. Push in all tube end caps
4.6. slide heater bracket on to pole and lock in place fig.4.
4.7. stand complete fig.5.
fig.2
© Jack sealey limited
instructions for
floor stand for Ir1000
Ir1000st.V2
model no:
fig.3
Original Language Version
fig.1
fig.4
ir1000st.V2 | issue 1 16/01/17