Sealey WPP3000S Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information, it is important that the following information is read and understood.
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is
8
replaced immediately by a qualified electrician.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
Extension cable use. Only use a cable designed for use with water equipment. Contact your dealer or a qualified electrician
for advice. Ensure water is kept clear of electrical mains power supply. DO NOT touch switch or plug with wet hands.
1.2. GENERAL SAFETY
WARNING! This pump must be used in accordance with Health & Safety, government, local authority and water authority rules and
‰
regulations including appropriate procedures for the protection of persons, animals, equipment and property.
Familiarise yourself with application, limitations and potential hazards peculiar to the pump.
9
WARNING! Disconnect the pump from the mains power before changing accessories, servicing or performing any maintenance.
‰
WARNING! DO NOT have contact with the water whilst the submerged pump is connected to the mains supply.
‰
Maintain the pump in good condition (use an authorised service agent). Keep the pump clean.
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Switch off the power on all devices that are in contact with the water before carrying out any cleaning or maintenance work on the device.
9
DO NOT operate the pump if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT use the pump for any purpose other than that for which it is designed.
8
DO NOT operate the pump out of water. The pump pick-up area must be completely submerged during operation.
8
DO NOT operate the pump during freezing temperatures. DO NOT leave the pump in water that may freeze.
8
DO NOT carry the pump by its electrical cable, or outlet pipe.
8
DO NOT use the device in water additionally chlorinated or in acidic or alkaline solutions.
8
DO NOT use in salt water.
8
DO NOT let the pump run dry. This can cause irreparable damage.
8
2. INTRODUCTION
Manufactured from high-impact stainless steel for added durability and corrosion resistance. Pond pump suitable for creating garden water
features. Also provides the important functions of filtration and water circulation which are necessary to maintain healthy plant and fish life.
Supplied with four adaptors.
© Jack Sealey Limited
1750L/3000L/3600L/HR STAINLESS STEEL
SUBMERSIBLE POND PUMP
WPP1750S, WPP3000S, WPP3600S
MODEL NO:
I
Original Language Version WPP1750S, WPP3000S, WPP3600S Issue:3 (H,F) 13/10/21
Recommended fuse rating
13 Amp