Siemens 5WG1 258-3AB11 Technical Product Information

Dusk sensor
Temperature sensor
Light sensor
Rain sensorheated
Wind sensor n.W heated
Wind sensor n.W heated
Wind sensor unheated
Heating transformer for Wind sensor heated
Product and Applications Description
Dusk sensor
The dusk sensor has the task of converting the current
light intensity at dusk into a corresponding electrical
signal. This electrical signal is detected by the central
controller and compared with the set dusk threshold
values. If the value falls below this limit, blinds can be
lowered for example or the exterior light can be
switched on.
Installation
The dusk sensor is mounted vertically on the mast
fixing provided. Due to the angle of illumination, the
device should be mounted so that the Siemens label is
located at the front of the device. The dusk sensor
should be aligned northwards. To ensure the faultless
recording of measured values, the sensor must not lie
in the shadow of a building or tree during the course of
the day.
Siemens AG
Automation and Drives Group
Electrical Installation Technology
P.O. Box 10 09 53, D-93009 Regensburg
Temperature sensor
The temperature sensor has the task of converting the
current external temperature into a corresponding elec-
trical signal. This electrical signal is detected by the
central controller and compared with the set tempera-
ture threshold values. The primary task of the tempera-
ture sensor is to protect the awning from frost damage.
Installation
The temperature sensor is installed in a location that is
protected from direct sunlight. Ideal locations are under
the eaves but not in areas where warm air can accumu-
late.
258/_1, 6 pages
© Siemens AG 2006
Subject to change without prior notice
GAMMA instabus
Technical Product Information
April 2006
5WG1 258-3AB11
5WG1 258-3AB21
5WG1 258-3AB31
5WG1 258-3AB41
5WG1 258-7AB02
5WG1 258-7AB03
5WG1 258-7AB13
5WG1 258-8AB01
Technical Manual
Update: http://www.siemens.de/gamma
2.13.2.7/1