Sealey LP13.V4 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Hot surfaces
instructions
1. SAFETY
1.1. GENERAL SAFETY
IMPORTANT: The LP13.V4 & LP14.V3 is a mobile, propane-fired, unvented, infrared space heater for commercial applications only.
It is designed for use with Propane cylinders of between 7kg to 15kg gas capacity.
WARNING! Outdoor use only!
‰
WARNING! Not for domestic use.
‰
Use only in well ventilated area.
9
DO NOT operate heater in leisure vehicles such as caravans and autocaravans.
8
WARNING! Heater will become very hot during use.
‰
WARNING! Read the instructions before use. This appliance must be installed in accordance with such regulations as are in force.
‰
Familiarise yourself with the application and limitations of the heater, as well as the potential hazards.
9
WARNING! Disconnect the heater from the gas supply before performing any maintenance.
‰
Maintain the heater in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
WARNING! Keep all guards and holding screws in place, tight and in good working order. The guard on this appliance is to prevent risk
‰
of fire or injury from burns and no part of it should be permanently removed. IT DOES NOT GIVE FULL PROTECTION FOR YOUNG
CHILDREN OR THE INFIRM. Check regularly for damaged parts. A guard or any other part that is damaged must be repaired or
replaced before the heater is next used. Avoid twisting the regulator's flexible tube. The tube should be inspected for damage regularly
and replaced if damage is found. Refer to the tube for its specification and length.
Keep gas hose away from heat, oil and sharp edges. Ensure that all connections are secure.
9
Keep the heater clean for best and safest performance.
9
Ensure the propane bottle is in a stable upright position before igniting the heater. DO NOT use with the bottle in any position other
9
than upright.
DO NOT use any fuel other than propane.
8
Ensure there are no flammable or combustible materials within 2 metres of the heater and that nothing, including walls, is less than
9
500mm from any surface of the heater.
DO NOT use the heater where there are flammable liquids, solids or gases such as paint solvents, etc.
9
WARNING! DO NOT use in basements or areas below ground level.
‰
DO NOT move the heater when it is operating.
8
DO NOT use the heater for any purpose other than that for which it is designed.
8
DO NOT operate the heater if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT adjust, or tamper with, the regulator.
8
DO NOT allow untrained persons to operate the heater.
8
DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
When not in use disconnect from the gas supply and store in a safe, dry, childproof area.
9
In the event of a gas leak immediately close the bottle valve, extinguish any flame and then place equipment in a well ventilated area,
9
preferably outdoors, and away from any heat sources (including strong sunlight). Rectify cause of leakage.
If a persistent leakage occurs notify a qualified service engineer.
9
DANGER! If the burner remains alight after the bottle valve has been closed DO NOT attempt to remove burner and/or regulator from
▲
the bottle. Contact your gas supplier
2. INTRODUCTION
Ceramic plaque space warmer/propane heater. Fitted with a piezoelectric button igniter which makes it quick and easy to ignite. For added
convenience it is supplied with 37mbar fixed regulator and 1.5m gas hose. Gas bottle not included. Self-standing with steel tube and built-in
handle makes it is easy and hassle free to move around any workshop or garage. Output of 14,330Btu/hr.
3. SPECIFICATION
MODEL NO: ......................................................................................................... LP13.V4, LP14.V3
Fuel Consumption: ....................................................................................................... 0.22-0.33kg/hr
Fuel: .......................................................................................................................................Propane
Output: ................................................................................................................10,250-14,330Btu/hr
© Jack Sealey Limited
14,330BTU/HR SPACE WARMER® PROPANE
HEATER - BOTTLE MOUNTING
MODEL NO:
Do not cover
Original Language Version
LP13.V4 & LP14.V3
LP13.V4 LP14.V3 Issue 2 19/04/23