Sealey LED318R Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
1.1. GENERAL SAFETY
Ensure the light is fully charged before initial use.
9
DO NOT turn the light on when it is being charged.
8
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the light.
8
DO NOT handle or move the light whilst it is being charged.
8
DO NOT use the light if you suspect that the battery or the light casing is damaged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in
9
your eyes, rinse thoroughly with cool water and seek immediate medical attention.
2. INTRODUCTION
i
Featuring a super bright 5W COB LED light source, which gives an even and constant spread of
light, producing up to 400 lumens. 3W High power SMD LED torch producing up to 100 lumens.
Integral hanging hook/belt clip with magnets and a magnetic base which can rotate through 180°
for hands-free applications. Features a battery level indicator. Rechargeable 3.7V 2Ah lithium-
ion battery for longer life, no memory effect and a much slower discharge than traditional Ni-MH
batteries. Built-in emergency power bank to charge mobile devices. Supplied with Micro USB
cable.
3. SPECIFICATION
i
M M odel No: odel No: ..................................... .....................................LED318G / LED318R
B B attery: attery: .......................................... .......................................... 3.7V 2Ah Lithium-ion
C C harging Time: harging Time: ........................................................... ...........................................................3hr
I I nput Voltage: nput Voltage: ....................................................... ....................................................... 5V~1A
L L ED Type: ED Type: ....................................... .......................................5W COB + 3W SMD
L L ength: ength: ................................................................ ................................................................ 190mm
L L umen Output: umen Output: ............................ ............................ Side - 400/Top - 100lm
O O perating Time: perating Time: ................................... ...................................Side - 3/Top - 5hr
O O utput: utput: ................................................................. ................................................................. 5V~1A
IMPORTANT WARRANTY INFORMATION
The battery fitted to this light is considered to be a consumable item and its ability to accept a charge will reduce over time. We will
provide warranty against mechanical and electrical defect for a period of one year - this DOES NOT cover fair wear and tear. If the
battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will
not replace the battery regardless of whether it is less than one year old.
4. OPERATION
4.1. CHARGING
4.1.1. Connect the USB lead to the input socket on the side of the light (fig.1).
NOTE: there is also an output socket (fig.3), which is used for charging mobile devices.
4.1.2. Plug USB lead into a power supply and turn on.
4.1.3. When the battery has fully charged the 5 GREEN LEDs on the rear will illuminate.
© Jack Sealey Limited
5W COB & 3W SMD LED RECHARGEABLE
INSPECTION LIGHT WITH POWER BANK
LED318 SERIES
MODEL NO:
LED318G / LED318R
3.7V 2Ah Lithium-ion
3hr
5V~1A
5W COB + 3W SMD
190mm
Side - 400/Top - 100lm
Side - 3/Top - 5hr
5V~1A
Original Language Version
LED318
SERIES
LED318 Series Issue 2 (ALL) 21/06/23