Sealey PC35 Instruction Manual

PLASTIC PIPE AND E X T R U S I O N C U T T E R S
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
WARNING! The blades used by these cutters are razor sharp and should be treated with due caution.
p
Store the cutters in a safe childproof place when not in use.
3
Use in a suitable, clean and tidy work area, free from unrelated materials. Ensure there is adequate lighting.
3
Use the cutters for rubber and soft vinyl pipes only.
3
DO NOT use cutters on hard reinforced pipe. If the blade does not penetrate the pipe, then the materials
7
used to make the pipe are too hard. Applying excessive pressure may cause the pipe to shatter.
DO NOT continue to attempt cutting any pipe that withstands penetration.
7
DO NOT insert a finger into the cutting area at any time.
7
DO NOT turn the pipe whilst cutting.
7
DO NOT allow untrained people to use the cutters.
7
DO NOT allow children to use or play with the cutters.
7
DO NOT use the cutters for tasks they are not designed to perform.
7
DO NOT operate cutters if any parts are damaged or missing as this may cause failure and/or personal injury.
7
DO NOT operate the cutters when you are tired, under the influence of alcohol, drugs or intoxicating
7
medication
.
2. INTRODUCTION
The PC35 & PC40 plastic pipe cutters have die cast aluminium bodies with heat treated AUS-8 grade stainless
steel blades. Both feature ratchet action cutting to avoid the crushing of pipes and push button blade retraction.
Suitable for cutting plastic pipes and extrusions.
PART NUMBERS FOR SPARE BLADES
PC35/B and PC40/B
PC40
Cutting capacity
6 - 42mm OD
I N S T R U C T I O N M A N U A L F O R :
PC35 & PC40
MODELS:
PC35
Cutting capacity
6 - 35mm OD
PC35, PC40 - 1 - 170504