Panasonic TB11N Series Installation Manual

I STAL
• Before starting to use this switch, please read through this
instruction manual to be familiar with the working procedure.
• The personnel for constructing the present machine shall be
qualified electric worker.
• The back is an instruction manual for the customer, and
never fail to hand this to him or her after the electric work.
TB11N
Safety precautions
&
WARNING
0
• Do not use this product for the machinery which will affect
people's life or the society seriously if it gets out of order
(medical equipment or large-scale facility, for instance).
Prohibit
0
• Never fail
· to reserve safety margin
and to build in safety devices such as redundant circuit whe
this product is used for the machine (heater, refrigerator etc.)
Obey
which may affect the
• Do not use this switch at a p aoe o cause bedewing.
Might cause electric
0
• Never fail to tum off the power supply when
installing or checking out.
If installed or checked without turning off the power,
Obey
the operator may be struck by electricity.
&CAUTION
• ever control directly the load over the rated.
0
Obey
•Clamp firmly the terminal screws.
If loosened, a fire might brea
0
• Never connect to the power source out of the rated.
Might cause a fire or other failures.
Prohibit
A
TB17N
in rating and performance
property if the gets out of
shoci<. a e--
"·e - 'a: ures.
waler or oil.
a fire or
other failures.
SllOci'
OUl
Precautions for installation
• Do not set up in
wrong
operation,
• a place at
• outdoor
• a place to cause bedewing
• a place with
• a place full of
• a place causing
• a place with high frequency, electric field or strong magnetic field
• The output circuit configuration is a same circuit type
(voltage-applied contact output).
The same voltage as the
erminal.
OU OU
•Do not con·use ne power terminal
If confused, shortcircuit, wrong operation or some other failures
may occur at the load circuit.
• In case of the load capacity over the rated or of three-phase,
use an electromagnetic contactor.
•After he installation, never
correct.
Then turn on the
•After the installation, never fail to use this time-switch without
the terminal cover. Might cause electric shock.
0
When mounted
.::
-a- e o :�e ;y:;:_
f ·n e S .,
,•, -n screws of 30 rr�
the M4 screw or he r<e
When fixing
reserve enough space
order.
cover to be remo ed.
f) When fixing to the panel
Use panel fixture (TB1782), optional one, to fix with.
�/,'�
�
�
:!:: g �
69. 5
a place with following conditions to prevent
failure and fault current.
or
-10 'C or less. -50 °( more
and exposed to rain or direc sunlight
corrosive gasses such as sulfurous acid or ammonia
humidity or dust
oscillation or impact
power terminal is applied to
and the
fail to make sure
mai n power supply to make a performance test.
_
How to install
(exposed) on a surface
_ cover
;er
·o :ne � & � :r J
... � c·
with ano her ae ce
'or - e
Dimensional
o'
s
�
�
��l
0
Panel
�
"'
"'
"' 0
"'
"'
"'
0
Can be fixed to the panel
up to 6 mm thick.
t�e
output terminal.
the connection is
;
Drawing
F. ng Pitch
Panel Fixture
Option:
( )
TB1782