Care And Cleaning - GE Side by Side 22 Dispenser Use And Care Manual

When Dispensing Ice...
Some crushed ice may be dispensed even though
you selected CUBES. This happens occasionally when
a few cubes get channeled to the crusher.
Sometimes a mound of snow will form on the door
in the ice chute. This condition is normal, and usually
occurs when you have dispensed crushed ice
repeatedly. The snow will eventually evaporate.
Caution: Never put fingers or other objects
into the dispenser opening.
To Stop Dispensing
Release pressure from the dispenser
pad and wait a few seconds to catch
the last bits of ice or drops of water.
There may be some dripping after ,
dispensing crushed ice or water. If ~
there is a lot of dripping, the spill r
should be wiped dry right away. '
Do not pour water in the spill shelf because it is not
self draining—pour it in the kitchen sink. The shelf
and its grille should be cleaned regularly according to
Care and Cleaning instructions. ~re~~ here t. ~emove grille
The grille is easily removed
by pressing on the back
right corner.
To Remove Ice Storage Bin
Lift the left corner to free the
bin from the shelf. Pull the bin
straight out while supporting it
at front and back.
If Ice Is Not Used
Often...
"Old" ice cubes will become cloudy and taste stale.
Empty ice storage bin periodically and wash it in
lukewarm water. Be sure to allow storage bin to cool
before replacing it+therwise ice cubes will stick to
the metal auger.
I
When Dispensing Water..
The first glass of water dispensed maybe warmer
than the following ones. This is normal.
Dispensed water is cool, not iced. For colder water,
simply add crushed ice or cubes before dispensing water.
If Ice Clumps Form in the Storage Bin...
The icemaker ejects cubes in groups of eight, and
it is normal for several cubes to be joined together.
However, if you don't use the ice very often ice
clumps may form in the storage bin and can
clog the dispenser.
If this happens:
Remove the storage bin from the freezer.
Break up ice clumps with your hands. Throw
away any clumps that you can't break up.
Replace the bin before the remaining cubes
melt and fuse together.
To Replace Ice Storage Bin
Slide the bin back until the tab on t
locks into the slot in the shelf.
If the bin does not go all the way
back, remove it and turn the drive
mechanism 1/4 turn. Then push the
bin back again until the tab on the
bin locks into the slot in the shelf.
7