Advertisement
KMC-17
Document Copyrights
Copyright 2008 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
HOW TO DISTINGUISH BETWEEN DIFFERENT VERSIONS OF THE KMC-17
There are two versions of the KMC-17; one uses Type A and the other uses Type B. The components of each of these parts
are not compatible with each other.
An external part of Type A and Type B for the KMC-17 is different, allowing you to distinguish between them, as described
below.
● KMC-17 (Type A)
The cap is attached on the upper part of the case.
● KMC-17 (Type A)
PLUG
ø3.5 3P
RED
SHIELD
PLUG
ø2.5 2P
BLACK
GREEN
2
SCHEMATIC DIAGRAM
+
0
MIC
(ECM)
PTT
+
0
SP
EARPHONE
JACK
ø2.5 3P
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
● KMC-17 (Type B)
The cap is not attached on the upper part of the case.
● KMC-17 (Type B)
PLUG
ø3.5 3P
CN3
4
3
PLUG
2
ø2.5 2P
1
+
CN1
R2
4
0
MIC
3
(ECM)
PTT
2
+
1
R1
SP
0
1
2
3
4
NC
EARPHONE
JACK
CN2
ø2.5 3P
Advertisement
