Page 2
“TRAITEMENT DES ACCUMULATEUR USAGÉS” CE PRODUIT CONTIENT UN ACCUMULATEUR À LITHIUM. CET ACCUMULATEUR USAGÉ DOIT ÊTRE TRAITÉ CORRECTEMENT. ENLEVEZ L’ ACCUMULATEUR DU PRODUIT ET PRENEZ CONTACT AVEC VOTRE AGENCE ENVIRONNEMENTALE LOCALE POUR DES INFORMATIONS SUR LES MÉTHODES DE RECYCLAGE ET DE TRAITEMENT. ER-A520/A530...
CHAPTER 1. GENERAL This manual describes the ER-A520/A530 disassembly procedures and the option attachment procedures. For assembly procedures, reverse the disassembly procedures. For attachment of options which do not require special descriptions, descriptions are omitted. Note for operations • Before operation, ground the operator’s body and perform other nec- essary measure against static electricity.
Note: Do not pull up the top cabinet unit the grounding wire and connector cables from the top Cabinet are re-moved. 3. REMOVING THE CABINET 1) Remove the cabinet fixing screw 1. 2) Slide the cabinet to the left, and remove the cabinet. ER-A520/A530 – 2 –...
The drawer unit should be securely fitted to the supporting platform to avoid instability when the drawer is open. The ER-A520 employs the following key top (option) to allow additional installation of the key top and change in the key layout.
Page 6
2) The key top of the ER-12KT7 and the ER-22KT7 includes the guide pin. Install the key top so that the guide pin is engaged with the spacer attached to the keyboard frame. ER-A520/A530 – 4 –...
S e c u r i n g t h e U P - P 1 6 D P t o t h e Screw (M4 x 16) wooden table Securing the UP-P16DP to the metal Screw (M4 x 20) table Securing the UP-P16DP to the metal table Fig. A ER-A520/A530 – 5 –...
2) Slide the cabinet to the left, and remove the cabinet. 3) Insert the pawl of the cabinet into the hole A at the back. 4) Slide the cabinet to the right. 5) Tighten the cabinet fixing screw 1. ER-A520/A530 – 6 –...
Page 9
¤ COPYRIGHT 2004 BY SHARP CORPORATION All rights reserved. Printed in Japan. No part of this publication may be reproduced, stored in a retrieval system, or transmitted. In any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of the publisher.