Gps Data; Landmarks - Nokia E71 User Manual

GPS data

Select Menu GPS GPS
> >
With GPS data, you can view your current location, find your
way to a desired location, and track distance.
Select Navigation to view navigating information to your
trip destination, Position
about your current location, or
traveling information such as the distance and duration you
have traveled, and your average and maximum speeds.
The application must receive positioning information from at
least four satellites to be used as a travelling aid.
The trip meter has limited accuracy, and rounding errors may
occur. Accuracy can also be affected by availability and quality
of GPS signals.
Use GPS data
To check the signal strength of the satellites that provide the
positioning information necessary for navigation, open any
of the three views and select
To set a landmark or location as the destination of your trip,
select Navigation Options
>
also enter the destination latitude and longitude
coordinates.
To remove the destination set for your trip, select
Navigation Options
>
To save your current position as a landmark, select
Navigation or Positionand
© 2010 Nokia. All rights reserved.
data.
to view positioning information
Trip dist. to view your
Options Satellite
>
Set destination. You can
>
Stop navigation.
>
Options Save position.
>
To activate the trip meter, select
Start. To stop the trip meter, select
To reset all fields and start calculating the trip again, select
Trip distance
To change the measuring system in use, select
Settings
>
To enter the altitude calibration to correct the altitude
received from the positioning satellites, select
Settings
>

Landmarks

Select Menu
Landmarks are coordinates to geographic locations that you
can save to your device for later use in different location-
based services. You can create landmarks using the internal
GPS receiver of your device or network (network service).
Create a landmark
status.
To create a landmark, select
Select Current position
latitude and longitude coordinates of your current location,
Select from map
manually to fill in necessary location information such as a
name, category, address, latitude, longitude, and altitude.
To show the landmark on the map, select
on map.
Trip distance
Options
Options > Restart.
>
Measurement system
Altitude calibration.
GPS > Landmarks.
>
Options
to make a network request for the
to select the location from a map, or
Options
> >
> Stop.
Options
>
Metric or Imperial.
>
Options
>
New landmark.
>
Enter
Options Show
>
79