Table of Contents
Advertisement
cloth. Accumulated dust may cause an insulation defect from
moisture, etc. resulting in a fire.
R Never touch the plug with wet hands. There is a danger of
electric shock.
Installation
R Place the unit securely on a stable, level surface. Serious
damage and/or injury may result if the unit falls.
R To prevent the risk of fire or electrical shock, do not expose
this product to rain or any type of moisture.
R Use this unit in a well ventilated area. Particularly, if you will be
using the unit for extended periods of time or will be printing in
large volumes, be sure to ventilate the room sufficiently.
Operating safeguards
R Turn the power switch OFF before cleaning. Do not use liquid
or aerosol cleaners.
R Do not cover slots and openings on the unit. They are provided
for ventilation and protection against overheating. Never place
the unit near radiators, or in a place where proper ventilation
is not provided.
R Never push any objects through slots in this unit. This may
result in the risk of fire or electric shock. Never spill any liquid
on the unit.
R To reduce the risk of electric shock, do not disassemble this
unit. Take the unit to an authorized service centre when service
is required. Opening or removing covers may expose you to
dangerous voltage or other risks. Incorrect reassembly can
cause electric shock when the unit is subsequently used.
R Follow all warnings and instructions marked on this unit.
R Do not spill liquids (detergents, cleansers, etc.) onto the
telephone line cord plug, or allow it to become wet at all. This
may cause a fire. If the telephone line cord plug becomes wet,
immediately pull it from the telephone wall jack, and do not use.
R Unplug this unit from power outlets and refer servicing to an
authorized service centre when any of the following conditions
occur:
–
If the power cord is damaged or frayed.
–
If the unit has been exposed to rain or water, or liquid has
been spilled into the unit. Do not use a microwave oven to
speed up the drying process of any parts of the unit
(including the cordless handset) to avoid permanent
damage.
–
If the unit does not work normally by following the operating
instructions. Adjust only controls covered by the operating
instructions. Improper adjustment may require extensive
work by an authorized service centre.
–
If the unit has been dropped or physically damaged.
–
If the unit exhibits a distinct change in performance.
USB cable/LAN cable
R To assure continued emission limit compliance:
–
use only shielded USB cable (Example: Hi-Speed USB 2.0
certified cable).
–
use only shielded LAN cable (Category 5 (Cat-5) Ethernet
cable).
Cordless handset communication (KX-MB2060 optional)
R Unplug from power outlets and never touch the inside of the
product if its casing has been broken open.
Detailed operating instructions are on the CD-ROM.
R Do not place or use this product near automatically controlled
devices such as automatic doors and fire alarms. Radio waves
emitted from this product may cause such devices to
malfunction resulting in an accident.
R Do not allow the AC adaptor or telephone line cord to be
excessively pulled, bent or placed under heavy objects.
R Consult the manufacturer of any personal medical devices,
such as pacemakers or hearing aids, to determine if they are
adequately shielded from external RF (radio frequency)
energy. (The product operates in the frequency range of 1.92
GHz to 1.93 GHz, and the RF transmission power is 115 mW
(max.).)
R Do not use the product in health care facilities if any regulations
posted in the area instruct you not to do so. Hospitals or health
care facilities may be using equipment that could be sensitive
to external RF energy.
1.1.2 CAUTION
Installation and relocation
R After moving the unit from cold areas to warmer areas, wait
approximately 30 minutes before turning on the power switch
to allow the unit to adjust to the ambient temperature. If the
power switch is turned on too soon after a sudden climate
change, condensation may form inside the unit, causing
malfunction.
R Never turn the unit upside down or sideways when moving it.
R Never install telephone wiring during a lightning storm.
R Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
R Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
R Use caution when installing or modifying telephone lines.
R Do not position the unit in a location where it is unstable or
subject to vibrations.
Operating safeguards
R When opening/closing the top cover, hold the indentations on
both sides of the unit (A).
–
To prevent injuries, be careful not to put your hands under
the top cover.
A
1. Important Information
A
3
Advertisement
Table of Contents
