Hp Digital Sender 9250C; Figure 1-25 Remove Formatter Cover - Hp Digital Sender 9250C; Figure 1-26 Remove Eio Plate - Hp Digital Sender 9250C - HP Access Control Install Manual

HP Digital Sender 9250c

To install the USB card reader on an internal USB port on the HP Digital Sender 9250c, complete the
following steps:
1. Turn off the power to the device.
2. Disconnect the power cable from the device.
3. Remove all cables from the formatter board.
4. Remove the formatter board.
a. Remove the two screws.
b. Gently pull the formatter board from the device.
Figure 1-25
5. Remove the existing EIO plate.
Figure 1-26
6. Insert the supplied EIO plate with cable protection. Make sure to route the card reader's USB cable
through the plate.
22 Chapter 1 External USB card readers
Remove formatter cover — HP Digital Sender 9250c
Remove EIO plate — HP Digital Sender 9250c
ENWW