Tt Mode - Sony KDL-32S5600 Service Manual

3-3. TT MOD E
The TT modes described below are available by selecting the two
relevant digits. You can exit the 'TT Mode' by entering 00, by
pressing the 'Analog' or the 'Digital' button, by switching the TV
set into Stand-by mode, or by Powering the TV set off.
00 'TT' mode off
Set volume to 35%
03
04 Set volume to 50%
Set volume to 65%
05
06 Set volume to 80%
Ageing mode on
07
08 Shipping Condition
09 WB Levels Check
19 Factory toggle mode (ON/OFF)
27 CBA mode toggle (ON/OFF)
31 ECS mode toggle (ON/OFF)
32 Set BCN channels preset
36 Full HD HDMI EDID Write
37 WXGA HDMI EDID Write
Re-initialise NVM
41
43 Select Dual Sound "A"
Select Dual Sound "B"
44
45 Select Dual Sound "Mono"
Select Dual Sound "Stereo"
46
48 Set NVM as non-virgin
49 Set NVM as virgin
59 Stop Main IIC Micro
69 WXGA /FHD Panel Selection
75 Set Centred Balance
76 Set Volume to Max
77 Set Volume to Min
78 Set Balance Full Left
Set Balance Full Right
79
81 Digital BER Display
TS CI Path Through
84
87 Front Panel Button Test
LED Test
89
92 TS CI Path Through With Reed Solomon Off
Note :
To place the Remote Commander in 'TT Mode' press the
following buttons together for approximately five seconds.
i+
(EXTERNAL INPUT) (ON SCREEN
(ON SCREEN
DISPLAY)
DISPLAY)
To use the Remote Commander in 'TT Mode' press the
'Red' text button on the Remote Commander twice.
TT Button
TT will then appear in the bottom right hand corner of the TV.
To take the Remote Commander out of 'TT Mode' press the
same buttons together for approximately five seconds.
- 15 -
+
5
(DIGIT 5) (DIGIT 5) (VOLUME +) (VOLUME +)
(DIGIT 5) (VOLUME +) (TV)