Advertisement
Connecting local virtual media or
8
smart cards (optional)
Connect virtual media devices or smart
card readers to any of the USB ports on the
GCM16 or GCM32 switch. To open a virtual
media session with a target device, the target
device must first be connected to the GCM16
or GCM32 switch using a virtual media
capable VCO or Virtual Media Conversion
Option G2 cable. To map a smart card with a
target device, the target device must first be
connected to the GCM16 or GCM32 switch
using a smart card capable Virtual Media
Conversion Option G2 cable.
Turning on target devices and
9
connecting power to the GCM16 or
GCM32 switch
Turn on each target device, then locate the
power cords that came with the GCM16 or
GCM32 switch. Connect one end into the
power socket on the rear of the GCM16 or
GCM32 switch and connect the other end
into an appropriate AC wall outlet. Repeat this
step for the second power cord to provide
redundant internal power supplies.
NOTE: Plugging the redundant power supplies
into separate branch circuits provides additional
redundancy in the event one external AC power
source loses power.
First Edition, July 2015. Copyright Lenovo 2015.
LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration "GSA" contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925.
Lenovo and the Lenovo logo are trademarks of Lenovo in the United States, other countries, or both.
Printed in USA
Quick Installation Guide
Quick Installation Guide
Global Console Manager
Global Console Manager
GCM16 | GCM32
GCM16 | GCM32
Connecting the GCM switch
PDU
7
9
NOTE: The network settings can be configured
via the local port using the local user interface
or from a VT100 terminal emulator connected to
the serial setup port.
Safety precautions
DANGER
Electrical current from power, telephone, and
communication cables is hazardous.
Target devices
8
External media
device
Local USB
GCM16 or GCM32 switch
connection
To avoid a shock hazard:
• Do not connect or disconnect any cables
or perform installation, maintenance, or
reconfiguration of this product during an
electrical storm.
• Connect all power cords to a properly
wired and grounded electrical outlet.
• Connect to properly wired outlets any
equipment that will be attached to this
product.
9
(GCM32 shown)
590-xxx-501A
Advertisement
