SERVICE MANUAL LCD Color Television 32HLC56 Rev.1 For Technical Bulletins, Technical Tips, or other information regarding the service of this model, visit the Toshiba America Consumer Products National Service Division website at: www7.toshiba.com This model is classified as a green product (*1), as indicated by the underlined serial number.
EXPRESS OR IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Toshiba shall not be liable for any damages, losses, expenses or costs, if any, incurred in connection with or as a result of use of any information or data provided herein.
Page 3
that have these same characteristics. Use only the specified parts when the mark is indicated in the circuit diagram or parts list. Part mounting and wire routing should be the same as that used originally. For safety purposes, insulating materials such as isolation tubes or tape are sometimes used and printed circuit boards are sometimes mounted floating.
Page 4
fluid should contact the skin or clothing, wipe off with alcohol, etc., and rinse thoroughly with water. If the fluid should enter the eyes, immediately rinse the eyes thoroughly with running water. When attaching the LCD module to the LCD cover, position it appropriately and fasten at the position where the display can be viewed most conveniently.
Page 5
CMOS-LSI circuitry is used in the LCD module, so avoid damage due to static electricity. When handling the module, use a wrist ground or anchor ground. Do not expose the LCD module to direct sunlight or strong ultraviolet rays for extended periods. Do not store the LCD module below the temperature conditions described in the specifications.
Entering Service Mode 1. Set VOLUME to minimum and press MUTE button once on remote control. ↓ 2. Press MUTE button again and hold button down. ↓ Service Mode display 3. While holding the MUTE button, press MENU button on TV set.
LED Indication The Red LEDs on the TV (at the bottom center of the TV) indicate the TV's status, as described below. • Red OFF = The TV is in a standby state. • Red ON = The TV is in a normal operation state. LED Indication Condition Solution...
Page 9
SIGNAL BOARD AV BOARD PANEL DDR RAM FLI8538 CORTEZ Plus VBI Data Processor PANEL I/F DCDi Video Analog Input MADi Decoder Front Terminal Scaling (Audio) (16port) LVDS CVBS(L/R) S-VIDEO(L/R) YCbCr(L/R) Channel Standby Process uCON Digital Input A EEPROM PC_IN(L/R) Digital Input B Micro- processor...
Page 14
Replacement Parts List Location Part No. Description A201 75002551 CESE/COVER/LID FRONT BEZEL ASSY A320 75002550 PIECE FRONT AV ASSY A340 75001920 PIECE BUTTON 7 KEY A401 75002549 CESE/COVER/LID BACK COVER ASSY A420 75001972 LEG STAND ASSY B001 75001844 DISPLAY, G5AUO32V5 C801 76503507 PLASTIC FILM, AC275V 0.22UF K C802 76503507 PLASTIC FILM, AC275V 0.22UF K C803 76168103 PLASTIC FILM 92T 400V 220NF J C804 76214103 CERAMIC DISC, 500V B 0.01UF K C805 76092281 CERAMIC DISC, AC250V E 4700PF C810 76125037 ELECTROLYTIC 692R 200V 1200UF M 3F C811 76092569 CERAMIC DISC, AC250V E 2200PF M C812...
Page 15
Replacement Parts List Location Part No. Description CE85 76073178 ELECTROLYTIC, 25V 3300UF M CE87 76669100 ELECTROLYTIC, 50V 10UF M CE90 76503047 PLASTIC FILM, 63V 0.33UF J CE91 76503041 PLASTIC FILM, 63V 0.1UF J CE92 76794101 ELECTROLYTIC, 16V 100UF M CE95 76092179 CERAMIC CHIP, 25V B 0.22UF K CE96 76073189 ELECTROLYTIC, 35V 1000UF M D801 23362200 DIODE, D5SB60, 7009F07 D805 23357627 DIODE, ZENER, RD9.1ESA B1 D806 23357666 DIODE, ZENER, RD27ESA B3 D809 23357654 DIODE, ZENER, RD36ESA B3 D810 23357666 DIODE, ZENER, RD27ESA B3 D811 23357511 DIODE, AG01A D812...