Hitachi PDA-100G Technical Data And Service Manual page 13

(6) Mount the Cord [58] <57> according to the following
procedure when replacing the standard cord (cord armor is
integrally molded).
1) Remove the standard cord (cord armor is integrally
molded) according to the procedure of 8-1 (3).
2) Strip the coating on the internal wire of the Cord
[58] <57> about 10 mm from the tip and crimp the
Terminal [54] <53> to the brown or black internal wire as
shown in Fig. 5.
3) Insert the Cord [58] <57> into the Cord Armor D8.8 [55]
<54>.
4) Cut off the rib for holding the cord of Tail Cover (B) [50]
<49> with nippers as shown in Fig. 6.
5) Mount the Cord [58] <57> and the Cord Armor D8.8
[55] <54> to Tail Cover (A) [39] <38> and secure them
with the Cord Clip [56] <55> and two Tapping Screw
(W/Flange) D4 x 16 [57] <56> as shown in Fig. 7.
6) Mount each internal wire reversing the removal
procedure. Then mount Tail Cover (B) [50] <49> to Tail
Cover (A) [39] <38> and secure them with the Tapping
Screw (W/Flange) D4 x 25 (Black) [51] <50>.
(a) For Taiwan and Korea
(c) For Singapore and Malaysia
Terminal [54] <53>
Caulking
(b) For China
Fig. 7-1
(d) For other countries
Fig. 7-2
--- 10 ---
Cord [58] <57>
Fig. 5
A --- A
Approximately
A
2 mm
: Cut off.
Tail Cover (B)
[50] <49>
A
Fig. 6