DeWalt DW624 Manual page 12

EN GLI SH
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
2
size is 1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Inserting and Removing a Cutter
(fi g. 2)
1. Press and hold down the spindle lock (d).
2. Using the 22 mm wrench, loosen the collet nut
(c) a few turns and insert a cutter (x).
3. Tighten the collet nut and release the spindle
lock.
WARNING: Never tighten the collet
nut without a cutter in the collet.
Replacing the Collet. (fi g. 3)
Your router is supplied with a 1/2" collet fitted to the
tool. Other precision collets are also available to suit
the cutter used.
1. Separate the collet (y) from the collet nut (c) by
pulling it firmly.
2. Click the new collet in place.
Setting the Electronic Speed Control
Dial (fi g. 1A)
DW625E
The speed is infinitely variable from 8,000 to 20,000
min -1 using the electronic speed control dial (b) for
uniform cutting results in all types of wood and
plastics.
10
Turn the electronic speed control dial to the required
level. The correct setting, however, is a matter of
experience.
1 = 8,000 min -1
2 = 12,000 min -1
3 = 16,000 min -1
4 = 18,000 min -1
5 = 20,000 min -1
Adusting the Depth of Cut (fi g. 1A)
Your router is equipped with a high precision depth
adjustment system including a revolver depth stop
(t), a measuring lens (l) and fine adjuster (q).
Quick Adjustment (fi g. 1A, 4)
1. Loosen the plunge lock (n) by pulling it up.
2. Lower the router carriage until the cutter is in
contact with the workpiece.
3. Tighten the plunge lock (n) by pushing it down.
4. For optimum ease of operation, the carriage
return can be adapted to the required depth of
cut by rotating or sliding the knurled nut (i).
5. Loosen the clamping screw.
6. Rotate the handwheel (k) until the fine adjuster
(q) touches the revolver depth stop (t).
7. Set the measuring lens to a round figure
(e.g. 0).
8. Adjust the depth of cut using the handwheel
(k) and the measuring lens (l). The distance
between the top of the revolver depth stop and
the bottom of the fine adjuster is the adjusted
depth of cut.
9. Tighten the clamping screw (o).
Triple Depth Adjustment Using the
Revolver Depth Stop (fi g. 5)
The revolver depth stop (t) can be used to set three
different depths. This is particularly useful for deep
cuts, performed in steps.
1. Place a depth template between the fine
adjuster (q) and the revolver depth stop (t) to
adjust the exact cutting depth.
2. If required, set all three screws.
WARNING: Make shallow cuts only!