Assembly And Adjustments - DeWalt DWE6005-XE Instruction Manual

FIG. 2
H
I
W
V
X
J
S
INTENDED USE
This laminate trimmer is designed for professional flush and bevel trimming of
laminated plastics and other similar materials that have a bonding agent too hard to
be trimmed with ordinary tools.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
This laminate trimmer is a professional power tool. DO NOT let children come into
contact with the tool. Supervision is required when inexperienced operators use this
tool.
A
L
M
T
R

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Inserting the Motor into the Fixed Base
(Fig. 1–3)
1. Open the locking lever (H) on the base.
2. If the depth adjustment ring (B) is not on the
motor, thread the depth adjustment ring (B) onto
the motor until the ring is positioned as shown.
Insert the motor into the base by aligning the
groove (F) on the motor with the guide pins (L)
on the base. Slide the motor down until the depth
adjustment ring (B) snaps into place.
3. Adjust the depth of cut by turning the depth
adjustment ring (B). Refer to Adjusting the Depth
of Cut.
4. Close the locking lever (H) when the desired
depth is achieved. For information on setting the
cutting depth, Refer to Adjusting the Depth of
Cut.
Motor Quick Release (Fig. 2)
1. Open the locking lever (H) on the base.
2. Grasp the base with one hand, depressing both quick release tabs (A).
3. With the other hand, grasp and pull motor from the base.
Bit Installation and Removal (Fig. 4)
SELECTING THE BIT
WARNING: Projectile hazard. Only use bits with 6.35 mm (1/4") shanks. Smaller
shank bits will not be secure and could become loose during operation.
These laminate trimmers are equipped with a 6.35 mm (1/4") diameter collet which accepts
6
FIG. 3