Removing The Holder Sensor Unit (Holder Upper Limit Sensor Ps110, Holder Lower Limit Sensor Ps111) - Canon Booklet Trimmer-A1 Service Manual

6.2 Removing the Holder Sensor Unit (Holder upper limit sen-
sor PS110, Holder lower limit sensor PS111)
1) As shown in 1.3, remove the rear cover.
2) Remove the 2 screws [1], and discon-
nect the connector [2]; and remove the
sensor holding plate (upper) [3], then,
detach the upper limit sensor PS110 [4].
Remove the 2 screws [5], and discon-
nect the connector [6]; and remove the
sensor holding plate (lower) [7], then,
detach the lower limit sensor PS111 [8].
You need to adjust the position
when mounting the holder sen-
sor (upper limit sensor or lower
limit sensor); perform either of
the following two:
i. Before removing the sensor
mounting plate [3, 4], mark
its current position on the
chassis using a pen or the
like; then, mount new one
back with reference to the
marking.
ii. After removing the sensor
mounting plate [3, 4], make
the following adjustments:
COPYRIGHT© 2002 CANON INC. 2000 CANON BOOKLET TRIMMER-A1 REV.0 FEB. 2002
CHAPTER 3 MECHANICAL SYSTEMS
F03-602-01
3-37