To Connect The Speaker Cords - Toshiba TY-AS100TW Operation Manual

CONNECTION
NOTE:
Make sure the antenna conductors do not touch any other terminals, connecting cords or the power cord.
Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord.
Otherwise, it could cause poor reception.
Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of
the System.
To wall outlet

To connect the speaker cords

Make sure both speakers are connected correctly and firmly.
When connecting the speaker cords, match the polarity of the speaker terminals: The black cord to (–), the red cord to (+).
Cautions
Do not connect more than one speaker to each terminal.
Do not allow the conductor of the speaker cords to be in touch with the metallic parts of the System.
Note:
If the speaker cords are covered with vinyl, remove the vinyl to with the metallic parts of the System.
120821_TY_AS100TW.indb 9
Do not connect the AC cord until all other connections have been made.
1. Push
2. Insert
FM Antenna (supplies)
(Extend the antenna and direct it to the optimal
direction where the sound quality is the best.)
For better FM reception
Disconnect the supplied FM antenna,
and fixed the tip of the antenna cord in
a place with good sensitivity.
3. Lock
9
12.8.21 4:56:08 PM