Appendix F: Using Pip And Pop - Mitsubishi Electric LT-3280 Owner's Manual

Appendix F: Using PIP and POP

You can display programs from analog channels, analog inputs or devices as Picture-In-Picture (PIP) and Picture-
Outside-Picture (POP). The media center has a second analog tuner for non-scrambled analog channels received
on Ant-1 and will display them as the PIP/POP sub-pictures. Digital channels and devices can be shown as the main
picture but cannot be the sub-picture. NOTE: PIP, POP and Side-by-Side modes do not support PC input.
Press PIP/POP to activate the PIP/POP option. With
each press of the PIP/POP button on the remote control
(within seconds of each other), the PIP/POP will cycle
through the following display options:
MAIN
Side-by-Side
PICTURE
MAIN
PICTURE
POP 1 POP 2
MAIN
POP 4 POP 5
PICTURE
POP 7 POP 8
Ant-1 2 XXXX
Standard
Stereo SAP
TV-PG DLSV
SQV1
Ant-1 2 XXXX
Standard
Stereo SAP
TV-PG DLSV
SQV1
Ant-1 2 XXXX
Standard
Stereo SAP
TV-PG DLSV
SQV1
Side-by-Side
POP 1
POP 2
3 POP
POP 3
POP 3
POP 6 9 POP
POP 9
PIP Ant-1 17
PIP large
PIP
PIP Ant-1 17
PIP small
PIP
PIP/POP Off
To turn PIP/POP off:
• Press PIP/POP repeatedly until the TV returns to full-screen
mode.
• Press PIP/POP and wait at least 10 seconds. Press PIP/
POP again. The next time you activate PIP/POP, the last-
used PIP/POP option will be displayed.
Changing PIP/POP Device
Press PIP DEVICE to change the PIP or POP picture source
device. A menu similar to the Device Selection menu will be
displayed.
Changing PIP/Side-by-Side Channels
Press PIP CH to scroll up and down through memorized
channels on Ant-1 and Ant-2.
Exchanging Program Images
Press EXCH to exchange the main picture and the PIP/POP
picture. Pictures from digital channels can only be shown as
the main picture.
Moving PIP Image
If no menus are on screen, press ADJUST
move the PIP display anywhere on the main screen.
Automatic POP Switching
When automatic POP switching is active, the TV will cycle
through memorized analog channels on Ant-1 or Ant-2 or strobe
pictures from other A/V components in the POP display. Press
PAUSE to pause or restart automatic POP switching.
Selecting POP "Live" Image
Press ADJUST , , or
image (automatic POP switching must be paused.)
Freezing the PIP and Side-By-Side Picture
Press PAUSE to freeze the PIP and side-by-side images. Press
PAUSE again to return to a "live" image.
IMPORTANT
Side-by-Side mode cannot show the same
channel or device on both sides.
If Ant-1 or Ant-2 is the main picture, Ant-2 is
not available as a PIP, POP or Side-by-Side.
PIP, POP and Side-by-Side mode are not
compatible with signals from memory cards.
PIP, POP and Side-by-Side modes are not
compatible with PC input.
, , or to
to select a different POP "live"
101