Programming The Water Softener - GE GXSF30V Owner's Manual & Installation Instructions

Programming the Water Softener.

When the transformer is plugged into the
electrical outlet, a model code and test number
(example: J3.4 & F30) are shown in the display.
Then, "12:00 PM" begins to flash. An arrow
displayed next to CLOCK on the face plate decal.
CONTROL OPERATION:
installation and after an extended power outage.
MODE/SET button to scroll arrow to
desired control function set.
DOWN buttons to change the settings of the
control.
MODE/SET button to accept changes.
control programming. One beep signals a
change in the control display. Repeated beeps
mean the control will not accept a change from
the button you have pressed, and you should
select another button.
e
SET TIME OF DAY
1. Press MODE/SET button until the arrow
is
2. Press the UP
upon initial
and
3. When the correct time is shown in the display,
16
points to CLOCK.
or DOWN
the present time. UP
ahead; DOWN sets the time back. Be sure
AM and PM is correct.
Salt Level
Clock
Hardness
Recharge
NOTE: Press buttons and quickly release to
slowly advance the display one number at a
time. Hold the buttons down for fast advance.
press MODE/SET to accept.
buttons to set
moves the display
PM