Connecting The System - Sharp PZ-MR2T Service Manual

Preparation

Connecting the system

1.
Connecting the system cable, the power cord and the speaker cables to the Plasma Display TV (Panel
Unit)
Plasma Display TV (Panel Unit) (rear view)
Speaker cable
(bottom view)
(WHITE)
System cable
• Two speaker cables of different lengths are supplied. As
shown in the diagram, connect the longer speaker cable
to the left speaker and the shorter to the right.
2.
Connecting the system cable and the power cord to the AVC System
AVC System (rear view)
ANT-A
OUT ANT/CABLE 75
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
POWER CORD CONNECTED.
Speaker cable
(GRAY)
Red
Black
Speaker cables
(GRAY GRAY with white stripe)
COMPONENT
Y P P
B R
INPUT 3
ANT-B
HD INPUT
MONITOR OUTPUT S-VIDEO VIDEO R-AUDIO-L
Black
As you apply pressure to this part,
insert the speaker cable. It is
important to match polarity when
connecting the speaker cables to the
terminals.
Power cord
Insert the speaker cable
Lift up the snap clip.
Insert the wire into
the hole of the
connector.
Lower the snap clip
to grip the wire in
place.
(GRAY)
COMPONENT
Y P P
B R
INPUT 1
RS-232C
DISPLAY OUTPUT-2
INPUT 2
S-VIDEO VIDEO R-AUDIO-L
7
PZ-MR2T
PZ-43MR2U
PZ-50MR2U
Red
System cable
(WHITE)
DISPLAY OUTPUT-1
AC INPUT
110V - 24OV
Power cord