Sharp LC-32HT3U Service Manual page 45

Start measurement
Repeat until RGB
become the target
values.
Completion of adjustment
2.7. Menu list in process A mode
Page Line
1 MAIN Version
BOOT Version
Monitor Version
PLIA Version
PI Status
EQ DATA CHECKSUM
TEMPERATURE
LAMP ERROR
NORMAL STANDBY CAUSE
ERROR STANDBY CAUSE
4 TUNER VCHIP TEST (69ch)
TUNER VCHIP TEST (7ch)
TUNER VCHIP TEST (4ch)
TUNER VCHIP TEST (10ch)
TUNER VCHIP TEST (15ch)
PC
Adjust RB to the target xy values.
MG1RXXXX
MG1BXXXX
* XXXX indicates the adjusted values between 0000 and 1023
(4 digit decimal number with zero fill).
* G is fixed.
* The default adjustment value of RGB is the parameter value of
the WBI1 command multiplied by 2.
Writing of adjusted values
MSET0003
Deleting adjustment patterns
MSET0000
Item
Main microcomputer software version
Monitor microcomputer software version
PLIA software version
Pro idiom operating status
Sound parameter checksum
Read value of temperature sensor
Number of lamp error
Reasons of standby at normal time
Reasons of standby in the event of error
Execute TUNER TEST
LC-32HT3U/LC-37HT3U/LC-42HT3U
The adjustment value is
reflected in the image.
Adjustment values are set.
OK
Writing is complete.
OK
Deletion is complete.
OK
Explanation
3 – 10
Set