Table of Contents
Advertisement
PZ-43HV2, PZ-43HV2E
PZ-43HV2U
ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED
SW POWER SUPPLY Module
When replaced
No adjustment required.
DIGITAL VIDEO Assy
When repaired
No adjustment required.
When replaced
• Remove IC1204 (24LC04(1) SN-TBB) from the former
PC Board to replace, and install it to the new PC Board.
MR INTERFACE Assy
1. Remove IC4201 from the former PC Board to replace,
and install it to the new PC Board.
2. Set slide SW according to page 222.
Y DRIVE
Assy
DIGITAL VIDEO
Assy
MR INTERFACE
Assy
Fig. 1 PC Board Location (rear side view)
Y DRIVE Assy
When repaired
1. VOFS/VH/IC5V voltage adjustment
2. Timing adjustment of pulse module
When replaced
1. SUSB ground timing adjustment
2. Panel white balance adjustment
X DRIVE Assy
When repaired
1. VRN voltage adjustment
2. Timing adjustment of pulse module
When replaced
1. SUSB ground timing adjustment
2. Panel white balance adjustment
SW POWER SUPPLY
Module
22
X DRIVE
Assy
Advertisement
Table of Contents
