Useful Tips; Faq - Sanyo FW55D25F Owner's Manual

7 Useful tips

FAQ

Question
●
●
●
●
My Remote Control does
●
not work.
What should I do?
●
●
●
How come the Initial Setup
●
appears every time I Turn
●
On this Unit?
●
●
●
Why can I not watch some
●
RF signal TV Programs?
●
●
●
How come there is no
image from the Connected
●
External Devices?
●
When I enter a channel
●
number, why does it
change Automatically?
Why are captions not
●
displayed Entirely?
Or why are captions
delayed behind the dialog?
How can I set the clock?
●
My PIN code no longer
●
works, how can I change
the Child Lock setting?
Check the Antenna or Cable Connection to the Main Unit.
Check the Batteries on the Remote Control.
Re-insert or replace the AAA Batteries with their Polarities (+/–) as indicated on the Remote Control Battery area.
Check if there is an obstacle between the infrared sensor window and the Remote Control.
Test the IR Signal Output use IR Signal Check. L p. 34
If okay, then possible Infrared Sensor trouble.
Aim the Remote Control directly at the infrared sensor window on the front of the Unit.
Reduce the distance to the Unit.
When there is an infrared-equipped device such as PC near this Unit, it may interrupt the Remote Control signal on this
Unit. Move the infrared-equipped device away from this Unit, change the angle of the Device's infrared sensor or Turn
Off the infrared communication function.
Connect the RF Coaxial Cable directly to this Unit and run the Initial Setup.
Make sure to complete the Initial Setup before the Unit goes into Standby mode.
Autoprogram must be completed when you Set Up the Unit for the First time or Move it to a location where previously
unavailable channels are broadcast.
Make sure Autoprogram has been completed. L p. 22
The selected channel may not be broadcasting.
When Autoprogram is interrupted and not completed, some channels will not be received. Make sure to complete the
Autoprogram. L p. 22
The selected channel cannot be viewed by the Child and Ratings Lock setting. L p. 25
The Unit requires some kind of Antenna Input. An indoor Antenna (Digital or VHF / UHF), an External Antenna (Digital or
VHF / UHF) or an RF Coaxial Cable from your wall Cable or Set-top Box needs to be plugged into the Unit.
Check if the correct Input mode is selected by pressing SOURCE or using CH H / I . Refer to Watching Channels from
an External Device. L p. 17
Check the Antenna, Cable or other Input Connection to the Unit.
When using the Component Video Connection check that the Green (Y), Blue (Pb/Cb) and Red (Pr/Cr) connectors are
connected to their corresponding colored jacks on the Unit.
Many Digital channels have alternate channel numbers. The Unit changes the numbers Automatically to the ones
signifying the Broadcasting Station's channel number. These basic numbers used for the previous Analog Broadcasts.
(e.g., Input Digital ch# 30 Automatically changes to Digital ch# 8.1)
Closed Captions that are delayed a few seconds behind the actual dialog are common for Live broadcasts. Most
captioning production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that
rate, selective editing is used to insure that the Closed Captions remain up-to date with the current TV screen dialog.
There is No clock function on this Unit.
If a Power failure occurs for longer than 10 seconds the child lock setting is retained, but the PIN code is reset to the
default code 0000. Refer to Child and Ratings Lock. L p. 25
Answer
32 .
English
Continued on next page.