Related Manuals for Electrolux ESL 6370RO
Summary of Contents for Electrolux ESL 6370RO
- Page 1 ..................... ESL 6370RO EN DISHWASHER USER MANUAL...
-
Page 2: Table Of Contents
12. ENVIRONMENT CONCERNS ..........16 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. -
Page 3: Safety Instructions
ENGLISH SAFETY INSTRUCTIONS Before the installation and use of the ap- • Always use a correctly installed shock- pliance, carefully read the supplied in- proof socket. structions. The manufacturer is not re- • Do not use multi-plug adapters and ex- sponsible if an incorrect installation and tension cables. - Page 4 Contact the • Do not drink and play with the water in Service to replace the water inlet hose. the appliance. • Do not remove the dishes from the ap- 1.3 Use pliance until the programme is comple- ted.
-
Page 5: Product Description
ENGLISH 2. PRODUCT DESCRIPTION Upper spray arm • When the programme starts to operate, the red light comes on and stays on for Lower spray arm all the duration of the programme. Filters • When the programme is completed, the Rating plate green light comes on. -
Page 6: Programmes
On/off button Delay button Programme buttons Indicators Indicators Description 3 hours indicator. 6 hours indicator. Multitab indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. End indicator. -
Page 7: Options
ENGLISH 5) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad odours to come out from the appliance. Do not use detergent with this programme. Information for test institutes For all the necessary information for test performance. -
Page 8: Before First Use
How to deactivate again the acoustic • The end indicator comes on. signal for the end of programme Press . The end indicator goes 1. Refer to “How to activate the acoustic off. The acoustic signal for the end of signal for the end of programme”... -
Page 9: Manual Adjustment
ENGLISH 2) Do not use salt at this level. You must adjust the water soften- er manually and electronically. Manual adjustment Turn the water hardness dial to the posi- tion 1 or 2. 6.2 Electronic adjustment • Intermittent acoustic signals and in- termittent flashing of the end indica- 1. -
Page 10: Daily Use
10 www.electrolux.com 6.4 Filling the rinse aid dispenser Press the release button (D) to open the lid (C). Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. -
Page 11: Hints And Tips
ENGLISH To set the appliance in user mode, do the Cancelling the delay start while Reset function. the countdown operates 1. Press and hold, at the same time, Do the Reset function. until the indicator When you cancel the delay start, comes on. -
Page 12: Care And Cleaning
12 www.electrolux.com softener. This makes sure that the water • Remove remaining food from the items. softener uses the correct quantity of dish- • To remove easily remaining burned washer salt and water. food, soak pots and pans in water be- fore you put them in the appliance. -
Page 13: Cleaning The Filters
ENGLISH 9.1 Cleaning the filters Turn the filter (A) counterclockwise and remove it. To disassemble the filter (A), pull apart (A1) and (A2). Remove the filter (B). Wash the filters with water. Put the filter (B) to its initial position. Make sure that it assembles correctly under the two guides (C). -
Page 14: Troubleshooting
14 www.electrolux.com 10. TROUBLESHOOTING The appliance does not start or it stops With some problems, different indica- during operation. tors flash continuously or intermit- Before you contact the Service, refer to tently at the same time to show an the information that follows for a solution alarm code. -
Page 15: Technical Information
ENGLISH Problem Possible solution The anti-flood device is on. Close the water tap and contact the Service. After the checks are completed, activate Refer to ‘HINTS AND TIPS’ for the appliance. The programme continues other possible causes. from the point of interruption. If the problem occurs again, contact the 10.2 How to activate the rinse Service. -
Page 16: Environment Concerns
16 www.electrolux.com max. 60 °C Water supply Cold water or hot water Capacity Place settings Power consumption Left-on mode 0.10 W Off-mode 0.10 W 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. - Page 17 ENGLISH...
- Page 18 18 www.electrolux.com...
- Page 19 ENGLISH...
- Page 20 www.electrolux.com/shop...