Consumer Mode; Consumer Mode Entry; Consumer Mode Navigation; Consumer Mode Exit - GE GFWS2500 Technical Service Manual

Test 25 Low Flow (Steam)
Water Valve Test
Test 26 Recirculation
Pump Test
Test 27 Overnight Dry
Fan Test
Consumer mode is a special mode that allows the consumer to see fault codes.

Consumer Mode Entry

• The control must be in the idle state to enter consumer mode.
• Simultaneously press and hold Power, Soil Level and Temperature for 3 seconds.

Consumer Mode Navigation

• Upon entering consumer fault code mode the control will display the number in HEX format.
• Fault codes will only be displayed if they are active.
• Pressing the Start key displays the next fault code in the fault code log.
• If there are no fault codes in the log, the control will display "―" on the seven segment display.

Consumer Mode Exit

• Press the Power key.
• The control will return to the idle state 30 minutes after entering consumer fault code mode.
• Disconnect power from the appliance.
• Press the Start key to begin the test.
• After the door locks the low fl ow water valve is energized and the
pressure sensor frequency is displayed in the display with 1 decimal
point of resolution. (i.e.: XX.X Hz. See Pressure Sensor for frequencies.)
Note: The control will continue fi lling until the overfl ow level is reached,
at that time the water valves will be turned off and the drain pump will be
energized until the tub is drained to empty
• Press the Start key to begin the test.
• The door locks and the cold water valve is energized until the main
water level is reached, at that time the cold water valve will be
de-energized and the recirculation pump will be energized.
Note: If the water level falls below the main water level, the recirculation
pump will de-energized.
• Press the Start key to begin the test.
• The door locks, the overnight dry fan is energized, and onr is displayed
in the display.

Consumer Mode

25