Kenwood TK-190 Service Manual page 11

4-3. Programming
1. Set the transceiver to Main Programming Mode. (Refer
to page 10)
2. Connect the KPG-36 to the transceiver.
3. Start up the programming software (KPG-59D), select
"firmware program" in the "Program" item, and press the
Return key on the personal computer. This starts up the
firmware programmer.
4. The top screen is displayed. Press any key to advance to
the next screen.
5. Set the communications speed (normally, 115,200bps)
and communications port in the Setup item.
6. Set the firmware to be updated by File select.
7. Held down the [Side 2] and [PTT]. Turn the transceiver
power on, and release [Side 2] first. Until the display
change to "P R O G • R • A • M • "
8. Check the connection between the transceiver and the
personal computer, and make sure that the transceiver is
in the Main Program Mode.
9. Press F10 on the personal computer. A window opens
on the display to indicate progress of writing. When the
transceiver starts to receive data, "PG" is appeared on 2
digit sub display.
10.If writing ends successfully, the red LED on the trans-
ceiver lights and the checksum is displayed.
11.If you want to continue programming other transceivers,
repeat steps 5 to 8.
Notes :
• To start the Firmware Programmer from KPG-59D, the
Fpro path must be set up by KPG-59D setup.
• This mode cannot be entered if the Main Program mode
is set to Disable in the Programming software (KPG-59D).
4-4. Function
1. If you press the [Top 2] key while "PROGRAM" is dis-
played, the checksum is displayed. If you press the [Top
1] key while the checksum is displayed, "PROGRAM" is
redisplayed.
2. A transmission speed can be selected by pressing the
[Top 1] key while "PROGRAM" is displaed.
19200bps : P R O G R A M •
38400bps : P R O G R A • M •
57600bps : P R O G R • A • M •
115200bps : P R O G • R • A • M •
Note :
Normally, write in the high-speed mode.
5. Panel Test Mode
Setting method refer to ADJUSTMENT.
REALIGNMENT
1dot lights
2dots light
3dots light
4dots light
TK-190
11