ELI-S-600
ELI SERIES EMERGENCY LIGHTING INVERTERS
Installation and Operation Instructions
! IMPORTANT SAFEGUARDS !
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. All servicing should be performed by qualified personnel only.
2. Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
3. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
4. Do not use this equipment for other than intended use.
5. Do not use outdoors.
6. Do not let supply cords touch hot surfaces.
7. Do not mount near gas or electric heaters.
8.
Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin
or eyes, flush acid with fresh water and contact a physician immediately.
CAUTION:
WARNING – Shut off AC power to branch circuits to which units will be connected. All wiring
should be per N.E.C. Articles 501-4(b) and local codes.
To maintain warranty, equipment with batteries must be installed or placed on charge within
prescribed period after shipment.
236 Mt. Pleasant Rd. • Collierville, TN USA 38017-2752 • Tech Support 888-263-4638 • Fax 901-853-5009 • www.philips.com/bodine
277 Volt
SAVE THESE INSTRUCTIONS
TO AVOID ELECTRICAL OVERLOAD, TOTAL CONNECTED LAMP LOAD (FACTORY AND
FIELD INSTALLED) SHOULD NOT EXCEED OUTPUT RATING.
SERVICE BY QUALIFIED PERSONNEL ONLY
© Philips Emergency Lighting
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
11/02/15
70100263