DeWalt D25901-XE Instruction Manual
  1. Manuals
  2. Brands
  3. DeWalt Manuals
  4. Power Hammer
  5. D25901-XE
  6. Instruction manual

DeWalt D25901-XE Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

INSTRUCTION MANUAL
D25901-XE, D25941-XE
DEMOLITION HAMMERS

Advertisement

Table of Contents
loading

Related Manuals for DeWalt D25901-XE

Summary of Contents for DeWalt D25901-XE

  • Page 1 INSTRUCTION MANUAL D25901-XE, D25941-XE DEMOLITION HAMMERS...
  • Page 2 FIG. 1 D25901 D25941...

  • Page 3: Definitions: Safety Guidelines

    1. WORK AREA Definitions: Safety Guidelines a. Keep work area clean and well lit. Cluttered and dark areas invite accidents. b. Do not operate power tools in explosive atmospheres, such as in the The definitions below describe the level of severity for each presence of flammable liquids, gases or dust.

  • Page 4: Extension Cords

    d. Remove any adjusting key or wrench before turning the power tool on. A 5. SERVICE wrench or a key left attached to a rotating part of the power tool may result in a. Have your power tool serviced by a qualified repair person using only personal injury.
  • Page 5 Safety Warnings for Impact demolition hammers • lead from lead-based paints, • crystalline silica from bricks and cement and other masonry products, and • Wear ear protectors. Exposure to noise can cause hearing loss. • arsenic and chromium from chemically-treated lumber (CCA). •...

  • Page 6: Components (Fig. 1)

    COMPONENTS (FIG. 1) Active Vibration Control WARNING: Never modify the power tool or any part of it. Damage or personal D25901, D25941 injury could result. The active vibration control neutralizes rebound vibration from the hammer A. On/off switch mechanism. Lowering hand and arm vibration, it allows more comfortable use for longer periods of time and extends the life of the unit.
  • Page 7 FIG. 2 FIG. 3 D25941 FIG. 4 FIG. 5 D25901 19 mm D25901 D25941 2. Insert the chisel shank into the tool holder/sleeve (E). Press and turn the chisel slightly until the sleeve snaps into position. 4. To remove a chisel, pull back the tool holder/sleeve (E) and pull the chisel out of 3.

  • Page 8: Maintenance

    Setting the Electronic Impact Energy Control Dial 4. Slide and rotate the side handle to the desired position. 5. Lock the side handle in place by tightening the clamp knob (J). D25901 (FIG. 1) Instructions for Use Turn the dial (C) to the desired level. The higher the number, the greater the impact energy.
  • Page 9 Cleaning For warranty repair information, call (AUS) 1800 654 155 or (NZ) 09 259 1111. This warranty does not apply to WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once • Accessories a week.
  • Page 12 20 Fletcher Road, Mooroolbark, VIC 3138 Australia (03 8720 5100) • 5 Te Apunga Place, Mt Wellington, New Zealand (09 259 1111) (FEB08) Part No. 1006463-04 D25901-XE, D25941-XE Copyright © 2008 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...

This manual is also suitable for:

D25941-xe

Table of Contents