Canon mp628 Service Manual page 16

Spur unit
Purge drive system unit
Carriage rail and main
chassis
Idler pulley parallel pin
Easy-Scroll Wheel base
APP code wheel gear shaft
Document pressure sheet
Document bottom cover
Scanner unit
Panel board ass'y
LCD viewer unit
Timing slit strip film
Timing slit disk feed film
Print head
Wireless LAN board ass'y
- DO NOT contact the spur edges. After replacement:
- Be cautious not to scratch or
damage the LCD cable.
- Upon contact with the film, wipe
the film with ethanol.
- Confirm no grease is on the film.
(Wipe off any grease thoroughly
with ethanol.)
- Do not bend the film
1. Check the ink system function.
2. Perform LF / Eject correction in
the service mode.
[See 3-3. Adjustment /
Settings, (6) Service mode, for
details.]
After replacement:
1. Confirm the purging operation
and the machine operation.
[See 3-4. Verification After
Repair for details.]
At replacement:
1. Apply grease to the sliding
portions.
[See 3-3. Adjustment /
Settings, (3) Grease
application, for details.]
After replacement:
1. Confirm the document pressure
sheet position.
[See 3-3. Adjustment /
Settings, (2) Document
pressure sheet replacement, for
details.]
At replacement:
1. Perform button and LCD test.
[See 3-3. Adjustment /
Settings, (6) Service mode, for
details.]
After replacement:
1. Perform print head alignment in
the user mode.
2. Perform LF / Eject correction in
the service mode.
[See 3-3. Adjustment /
Settings, (6) Service mode, for
details.]
After replacement:
1. Perform print head alignment in
the user mode.
After replacement:
1. Reset the LAN settings in the
user mode.
2. Print the EEPROM information
to confirm that the WL LAN
MAC address is properly
updated.
[See 3-3. Adjustment /
Settings, (6) Service mode, for
details.]
14 / 44
- EEPROM information print
- Service test print
- Service test print
- Service test print
- Service test print
- Service test print
- EEPROM information print
- Service test print
- Service test print
- EEPROM information print
- Service test print