Using The Dual Mono Mode; Using The Direct Control; Using The Dolby Pro Logic; Setting The Speaker Setting - Pioneer AXM-P7050 Operation Manual

Section
07 Digital Signal Processor

Using the dual mono mode

When playing a disc recorded on a dual mono
mode, you can select the channel to output.
! This function is effective only on dual mono
mode sound.
1 Press p to select D.MONO.
Press p until D.MONO appears in the dis-
play.
# When playing other than the DVD disc, you
cannot switch this mode.
2 Press m or n to select the desired
output setting.
Each press of m or n selects output set-
ting in the following order:
L&R (left and right channels)L ch (left chan-
nel)R ch (right channel)

Using the direct control

You can override audio settings to check for ef-
fectiveness of your audio settings.
1 Press p to select DIRECT.
Press p until DIRECT appears in the display.
2 Press r to turn the direct control on.
DIRECT ON appears in the display. Direct con-
trol is now on.
# To turn direct control off, press q.
Notes
! All audio functions are locked out during
DIRECT ON except VOLUME.
! If the source is a 2-channel LPCM audio or a
2-channel Dolby Digital audio and you select
DIRECT ON, audio is heared only over front
left/right speakers.
22
En

Using the Dolby Pro Logic

Dolby Pro Logic gives enhanced spatial and di-
rectional effects, creating theater-like sense of
presence and ambience.
! If the source is a 2-channel LPCM audio or
a 2-channel Dolby Digital audio and you se-
lect SFC effects that are most applicable
for 5.1-channel audio (i.e., Musical, Drama
or Action), we recommend turning Dolby
Pro Logic on. On the other hand, when se-
lecting SFC effects that are intended for
use with 2-channel audio (i.e., Jazz, Hall or
Club), we recommend turning Dolby Pro
Logic off.
1 Press p to select Dolby PL.
Press p until Dolby PL appears in the dis-
play.
2 Press r to turn the Dolby Pro Logic
on.
Dolby PL ON appears in the display. Dolby
Pro Logic is now on.
# To turn Dolby Pro Logic off, press q.
Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
! No audio is output if the center speaker set-
ting is SMALL or LARGE and no center speak-
er is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.

Setting the speaker setting

You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to LARGE (large)