Pioneer DVD Installation Manual page 40

seconds (until the red light at the end of the remote lights up and stays on when you
release the buttons).
TV power, volume,
To Control:
mute, and TV
Input
TV PWR and TiVo
Press the:
buttons
2. Enter the search code. Refer to the table below and use the number keys on your
remote control to enter the appropriate code.
TV power, volume,
To Test:
mute, and TV Input
0999
Enter:
After you press the fourth digit of the code, the red light on the end of the remote
control will flash twice, then remain on.
3. Test the remote control. Point the remote control at the TV or A/V receiver. Press
CHAN UP to test the first code. The test is successful if the TV or A/V receiver
responds (by powering off, changing input, or muting, depending on the function you
are trying to program). If there is no response, wait two or three seconds, then press
CHAN UP again. Continue doing this until the TV or A/V receiver responds.
When the TV or A/V receiver responds, press ENTER to select the current code. The
red light at the end of the remote control will flash three times to indicate that the
remote control is properly coded to control your device.
I n s t r u c t i o n s : P o w e r , V o l u m e , M u t e , T V I n p u t
TV input only A/V system
power
TV INPUT and TV PWR and TiVo
TiVo buttons buttons
TV input only A/V system
power
0999 1999
A/V system
volume and
mute
MUTE and TiVo
buttons
A/V system
volume and mute
1999
4
35