Advertisement
5. Install the tray assembly.
a. Fully extend the sliding rails until locked (1).
b. Place the tray assembly on the rails, aligning the screw
holes on the tray with the tabs on the rails (2).
c. Secure with two 6-32 screws on each side (3).
3
3
6. Attach the cable management arm to the rear of the tray with
two 6-32 screws.
7. Carefully route the keyboard power and video cables into the
cable management arm. Then route the cables through the
mounting rail opening.
3
3
2
1
1
HP CONFIDENTIAL Writer: Amy L. Laffitte Codename:RUGER Part Number: 230201-022 Last Saved On: 9/3/02 3:33 PM
8. Place the tray back into the rack.
a. Slide the locking bar (1) to unlock.
IMPORTANT: If the TFT5600 RKM is not properly aligned with other
rack-mounted devices when installed, cosmetic damage to the top of the
unit can occur due to interference. Leave protective sheet on the unit
while adjusting.
b. Carefully push the tray (2) into the rack.
IMPORTANT: If the TFT5600 RKM interferes with the other rack-mounted
devices, above or below, loosen the M-6 screws on the mounting rails to
make appropriate adjustments.
Installation is complete.
Advertisement
