Table of Contents
Advertisement
Q
: It takes a while to display picture on the screen after turning power on
or after changing channel.
A
: In case of digital broadcasting, it could take 1 to 2 seconds to receive data. Therefore, it is not
a inferior STB if the screen displays picture at the end.
Q
: There is no picture on the screen.
A
: Make sure the power is on.
Make sure the cable between the product and TV is connected properly.
Make sure TV's external video input mode is selected correctly.
Make sure STB's video output mode is selected correctly.
In case antenna cannot receive signal due to weak broadcasting signal, picture may not
display on the screen.
Try turning STB back on.
Q
: Poor video quality or screen flickering.
A
: It results from the weak signal of your local digital broadcasting.
Q
: No sound.
A
: Make sure cable between STB and the TV audio jack is connected properly.
Try MUTE button.
Check audio control button.
Try turning STB back on.
Q
: The remote control does not work.
A
: Make sure the remote control sensor is not covered by other obstacle.
Check that the batteries are installed with the correct polarities (+ and -).
47
Advertisement
Table of Contents
