Disassembly - Pioneer DVR-231-S Service Manual

5

7.1.6 DISASSEMBLY

QQ
Note 1: Do NOT look directly into the pickup lens. The laser beam may cause eye injury.
3 7 63 1515 0
Note 2: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
Note 3: For performing the diagnosis shown below, the following jigs for service is required:
• Flexible cable for service (GGD1436)
• Emergency disc ejection rod (GGF1529)
• Clip type heatsink (GGF1528)
1. Diagnosis of the MAIN Assy
1
Bonnet Case S
1
Remove the three screws.
1
2
Remove the five screws.
3
Remove the bonnet case S.
TE
L 13942296513
2
www
.
5
http://www.xiaoyu163.com
6
1
Rear view
3
Bonnet case S
2
×3
x ao u163
y
i
6
http://www.xiaoyu163.com
2 9
8
2
Tray Panel
1
Press the
2
Press the 0 OPEN/CLOSE button to open the tray.
3
Remove the tray panel.
4 Press the 0 OPEN/CLOSE button to close the tray.
5
Press the
1
Q Q
3 6 7 1 3 1 5
1
How to open the tray when the power cannot be turned on
When the tray cannot be opened because the power cannot be
turned on, it can be opened using the emergency disc ejection
rod (GGF1529). (A long, thin rod about 1 mm in diameter can be
used in place of the rod.)
Insert the rod through the slit at the bottom of the unit and slide
the projection for cam R9 in the direction of the arrow, using the
rod. When the tray is popped out a little, pull it out by hand. Find
the projection by inserting the rod through the slit by about 20
mm, as the projection is not visible from the outside. If the
insertion of the rod exceeds 20 mm, you cannot catch the
projection.
2
Emergency disc ejection rod
(GGF1529)
Tray
Bottom view co
.
DVR-231-S
7
9 4 2 8
STANDBY/ON button to turn on the power.
STANDBY/ON button to turn off the power.
2 4
0 5 8 2 9 9 4 2 8
5
Emergency disc ejection rod
(GGF1529)
about
5mm
about
15mm
m
Cam R9
Slit
Bottom view
7
8
9 9
A
B
Tray
3
C
2
4
Tray panel
9 9
D
Slit of chassis
E
Slit of drive
Projection
(slide)
F
59
8