Panasonic U-26PE1U6 Technical Data & Service Manual page 168

<Procedure of CZ-RTC3 /CZ-RTC5>
Stop the system before performing these steps.
1 Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the LCD display.
2 Press the or
If you wish to see the next screen instantly, press the
or button.
Select "8. Detailed settings" on the LCD display and press
the button.
1
The "Detailed settings" screen appears on the LCD display.
3 Select the "Unit no." by pressing the
for changes.
4 Select the "Code no." by pressing the
Change the "Code no." to "
button (or keeping it pressed).
=91
, and buttons
button to see each menu.
or button
or button.
" by pressing the or
Electrical component box
=90
=93
=92
5 Select the "Set data" by pressing the
Select one of the Setting Data "YYYY" by pressing the
or button.
Then press the
Flap position
5
* Setting data "
Setting data
Without separate setting
Swing
Move to position
Move to position
Move to position
Move to position
Move to position
When the flap position is set to
in the cooling or dry mode, the flap position is moved to
3 and the operation is started. (refer to Fig. 1-142)
NOTE
The flap swings during the operation under "Setting the
Flap Separately".
At this time, the unselected flaps are moved to the
position . (refer to Fig. 1-142)
1
6 Press the button.
The "Exit detailed settings and restart?" (Detailed setting-
end) screen appears on the LCD display.
Select "YES" and press the
1-160
1. Specifications
or
button.
1
2
3
4
Fig. 1-142
" (refer to Fig. 1-142)
Flap position during operation
and stay
1
and stay
2
and stay
3
and stay
4
and stay
5
or and the unit is
4 5
button.
button.